Mazda 3 Service Manual: Emissions

Thermostat Removal/Installation [Mzr 2.0, Mzr 2.5]

WARNING: Never remove the cooling system cap or loosen the radiator drain plug while the engine is running, or when the engine and radiator are hot. Scalding engine coolant and steam may ...

Canister Vent (Cv) Solenoid Valve Inspection [Mzr 2.0, Mzr 2.5]

Except for Mexico Airflow inspection 1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove the CV solenoid valve.. 4. Inspect airflow between the ports under the f ...

Other materials:

Base Removal
1. Remove the rearview mirror.. 2. Wind each end of a wire around a bar. WARNING: Using the piano wire with bare hands can cause injury. Always wear gloves when using the piano wire. NOTE: Use a long sawing action to spread the work over the whole length of the pi ...

General Procedures (Suspension)
Wheel and Tire Installation 1. When installing the wheels and tires, tighten the wheel nuts in a criss-cross pattern to the following tightening torque. Tightening torque 88—118 N·m {9.0—12 kgf·m, 65—87 ft·lbf} Suspension Links Removal/Installation 1. For the joint sections ...

Rear Washer Hose Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the front mudguard (RH).. 3. Disconnect rear washer hose A from the washer motor. 4. Remove the rear washer hose A from clip A, B, C, D, E, F, G. 5. Disconnect joint pipes and remove rear washer hose A. 6. Partially peel back the sea ...