Mazda 3 Service Manual: Engine

Starter Removal/Installation [Mzr 2.0, Mzr 2.5]

WARNING: Remove and install all parts when the engine is cold, otherwise they can cause severe burns or serious injury. When the battery cables are connected, touching the vehic ...

General

...

Other materials:

Afs (Adaptive Front Lighting System) Off Switch Inspection
1. Disconnect the negative battery cable.. 2. Remove the AFS OFF switch.. 3. Verify that the continuity between the AFS OFF switch terminals is as indicated in the table. If the continuity is not as indicated in the table, replace the AFS OFF switch. 4. Apply battery po ...

Passenger Compartment Temperature Sensor Inspection [Full Auto Air Conditioner]
1. Measure the temperature around the passenger compartment temperature sensor and measure the resistance between passenger compartment temperature sensor terminals B and D. If the characteristics of the passenger compartment temperature sensor are not as shown in the graph, repla ...

Liftgate Latch And Lock Actuator Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Liftgate upper trim. b. Liftgate side trim. c. Liftgate lower trim. 3. Disconnect the connector. 4. Remove the bolts. 5. Remove the liftgate latch and lock actuator. 6. Install in the reverse order o ...