Mazda 3 Service Manual: Engine Assembly

Refrigerant Pressure Sensor Removal/Installation [Manual Air Conditioner]

1. Disconnect the negative battery cable.. 2. Discharge the refrigerant.. 3. Disconnect the refrigerant pressure sensor connector. CAUTION: If moisture or foreign material enters the ref ...

Crank, Balancer

...

Other materials:

Maintenance of the Active Driving Display
The combiner and mirror surface have a special coating. When cleaning, do not use a hard or rough-surface cloth, or cleaning detergent. In addition, if a chemical solvent gets on the active driving display, wipe it off immediately. Otherwise, the combiner and mirror could be damaged and the s ...

No.7 Bsm Indicator Light Does Not Flash While Under Bsm Indicator Light Flashing Conditions (With Combination Switch Operation (Turn Signal Switch)) [Blind Spot Monitoring (Bsm)]
7 BSM indicator light does not flash while under BSM indicator light-flashing conditions (with combination switch operation (turn signal switch)) Description The BSM indicator light does not flash or illuminate continuously, ...

Rear Buckle Removal/Installation
Rear Buckle (RH) and Rear Buckle (Center) 1. Remove the rear seat cushion.. 2. Remove the bolt. 3. Remove the rear buckle (RH) and rear buckle (center). 4. Install in the reverse order of removal. Rear Buckle (LH) 1. When removing or installing the rear buckle (LH), refer to the rear ...