Mazda 3 Service Manual: Engine Coolant Temperature (ECT) Sensor Inspection [Mzr 2.0, Mzr 2.5]

Mazda 3 Service Manual / Engine / Control / Sensors, Switches, Relays / Engine Coolant Temperature (ECT) Sensor Inspection [Mzr 2.0, Mzr 2.5]

ECT Sensor No.1

Resistance inspection

WARNING:

When the engine is hot, it can badly burn. Turn off the engine and wait until it is cool before removing the ECT sensor.

1. Remove the battery cover..

2. Disconnect the negative battery cable..

3. Drain the engine coolant..

4. Remove the battery and battery tray..

5. Disconnect the ECT sensor No.1 connector.

6. Remove the ECT sensor No.1..

7. Place the ECT sensor No.1 in water with a thermometer, and heat the water gradually.

8. Measure the resistance between ECT sensor No.1 terminals A and B.

If not as specified, replace the ECT sensor No.1..

Specification


ECT (°C {°F})	Resistance (kilohms)
20 {68}	Approx. 37.34
80 {176}	Approx. 3.84

ECT Sensor No.2 Inspection

Resistance inspection

WARNING:

When the engine is hot, it can badly burn. Turn off the engine and wait until it is cool before removing the ECT sensor.

1. Remove the battery cover..

2. Disconnect the negative battery cable..

3. Drain the engine coolant..

4. Disconnect the ECT sensor No.2 connector.

5. Remove the ECT sensor No.2..

6. Place the ECT sensor No.2 in water with a thermometer, and heat the water gradually.

7. Measure the resistance between ECT sensor No.2 terminals A and B.

If not as specified, replace the ECT sensor No.2..

Specification


ECT (°C {°F})	Resistance (kilohms)
20 {68}	Approx. 2.45
80 {176}	Approx. 0.318

Crankshaft Position (CKP) Sensor Removal/Installation [Mzr 2.0, Mzr 2.5]

Removal CAUTION: When foreign material such as an iron chip is on the CKP sensor, it can cause abnormal output from the sensor because of flux turbulence and adversely affect the engine ...

Engine Coolant Temperature (ECT) Sensor Removal/Installation [Mzr 2.0, Mzr 2.5]

WARNING: When the engine is hot, it can badly burn. Turn off the engine and wait until it is cool before removing the ECT sensor. ECT Sensor No.1 1. Remove the battery cover.. 2. D ...

Other materials:

Schedule 2
Chart symbols: I: Inspect: Inspect and clean, repair, adjust, fill up, or replace if necessary. R: Replace L : Lubricate C: Clean T: Tighten Remarks: *1 Use of FL-22 is recommended when replacing engine coolant. Using engine coolant other than FL-22 may cause serious damage to the en ...

Driveline/Axle SST
49 F027 004 Attachment ø80 49 U027 005 Bearing installer 49 H027 002 Bearing remover 49 H034 201 Support block 49 H028 203 Block S ...

Variable Valve Timing Actuator Inspection [Mzr 2.3 Disi Turbo]
CAUTION: Variable valve timing actuator cannot be disassembled because it is a precision unit. 1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove the charge air cooler.. 4. Remove the ignition coils.. 5. Disconnect the ventilation hose from th ...