WARNING:
When the engine is hot, it can badly burn. Turn off the engine and wait until it is cool before removing the ECT sensor.
ECT Sensor No.1
1. Remove the battery cover..
2. Disconnect the negative battery cable..
3. Drain the engine coolant..
4. Remove the battery and battery tray..
5. Disconnect the ECT sensor No.1 connector.
6. Remove the ECT sensor No.1 using the SST
.
7. Install in the reverse order of removal.
8. Refill the engine coolant..
ECT Sensor No.2
1. Remove the battery cover..
2. Disconnect the negative battery cable..
3. Drain the engine coolant..
4. Disconnect the ECT sensor No.2 connector.
5. Remove the ECT sensor No.2 using the SST
.
NOTE:
Wipe off any oil or engine coolant if it gets on the ECT sensor No.2 installation area.
6. Install in the reverse order of removal.
7. Refill the engine coolant..
Electrical System
Electrical Parts
Battery cable
Before disconnecting connectors or removing electrical parts, disconnect
the negative battery cable.
Wiring Harness
To remove the wiring harness from the clip in the engine room, pry up the
hook of the clip using a flathead screwdriver. ...
Driving on Uneven Road
Your vehicle's suspension and underbody can be damaged if driven on
rough/uneven roads
or over speed bumps at excessive speeds. Use care and reduce speed when
traveling on
rough/uneven roads or over speed bumps.
Use care not to damage the vehicle's underbody, bumpers or muffler(s) when
dr ...
Cell Phones
WARNING
Please comply with the legal regulations concerning the use of
communication
equipment in vehicles in your country:
Use of any electrical devices such as cell phones, computers, portable
radios, vehicle
navigation or other devices by the driver while the vehicle is ...