Mazda 3 Service Manual: Entertainment Personalization Features Setting Procedure
Welcome Mode ON/OFF Setting
NOTE:
-
WELCOME mode is controlled by the instrument cluster. Refer to the instrument cluster description.
1. Refer to INSTRUMENTATION/DRIVER INFO. PERSONALIZATION FEATURES SETTING PROCEDURE.
Welcome Sound ON/OFF Setting
1. Switch the ignition to ACC or ON.
2. Turn the audio unit power to ON.
3. Press the AUDIO CONT switch.
4. Select “Welcome ON” or “Welcome OFF”.
5. Press the AUDIO CONT switch.
6. Select “ON” or “OFF”.
Action Illumination ON/OFF Setting
1. Switch the ignition to ACC or ON.
2. Turn the audio unit power to ON.
3. Press the AUDIO CONT switch.
4. Select “ILLM EFT ON” or “ILLM EFT OFF”.
5. Press the AUDIO CONT switch.
6. Select “ON” or “OFF”.
Switching between SIRIUS satellite radio unit equipped/not equipped
NOTE:
-
Do not operate the command for the Sirius radio because it is used for the factory inspection.
1. Connect the M-MDS (IDS) to the DLC-2.
2. After the vehicle is identified, select the following items from the initial screen of the M-MDS.
-
Select the “Module Programming”.
3. Then, select items from the screen menu in the following order.
-
Select “Programmable Parameters”.
-
Select “Audio Configure”.
|
M-MDS display |
Function |
Setting |
||
|
Sirius radio |
Perform a write on the instrument cluster for whether or not a SIRIUS satellite radio unit is equipped. |
NOTE:
|
||
Confirmation Step 3: Antenna System Simple Inspection [Radio]
Because the antenna system is equipped with a capacitor, the continuity cannot
be checked. Therefore proceed the following simple inspection.
Turn the AM radio on.
Tun ...
Entertainment System
Outline
Auxiliary jack/USB port has been adopted.
USB adapter has been adopted.
An audio unit which supports USB devices such as USB memory or iPods has
been adopted.
...
Other materials:
How to Use Pandora
What is Pandora ® ?
Pandora ® is free personalized Internet radio. Simply enter a favorite
artist, track, genre,
and Pandora ® will create a personalized station that plays their music and more
like it.
Rate songs by giving thumbs-up and thumbs-down feedback to further refine your
station ...
Rain Sensor Removal/Installation
1. Disconnect the negative battery cable..
2. Spread open the rain sensor cover in the direction of the arrows and disengage
tabs A to remove it.
3. Disconnect the rain sensor connector.
4. Slide rain sensor tab B in the direction of the arrow shown in the figure
and detach tab B. ...
General Procedures (Brake)
Wheel and Tire Installation
1. When installing the wheels and tires, tighten the wheel nuts in a criss-cross
pattern to the following tightening torque.
Tightening torque
88—118 N·m {9.0—12 Kgf·m, 65—87 ft·lbf}
Brake Lines Disconnection
1. If any brake line has been disconnec ...
