Mazda 3 Owners Manual: Fog Lights
Use this switch to turn on the fog lights.
The fog lights will improve visibility at night and during foggy conditions.
To turn the fog lights on, rotate the fog
light switch to the 
position.
The headlight switch must be in the
position before turning on the fog lights.
To turn the fog lights off, do any of the following:
- Rotate the fog light switch to the
position. - Turn the headlight switch to the
or
position.
NOTE
- The fog lights will turn off when the headlights are set at high beams.
- (With auto-light control)
If the fog light switch is in the
position and the headlight switch is in the
position, the fog lights
will turn on when the headlights, the exterior lights and dashboard illumination turn on.
Daytime Running Lights
Some countries require moving vehicles
to have their lights on (daytime running
lights) during the daytime.
Daytime running lights turn on
automatically when the ignition is
switched ON.
The ...
Turn and Lane-Change Signals
The ignition must be switched ON to use
the turn and lane-change signals.
Turn Signals
Move the signal lever down (for a left
turn) or up (for a right turn) to the stop
position. The signal will ...
Other materials:
Brake Hose (Front) Removal/Installation [Mzr 2.0, Skyactiv G 2.0, Mzr 2.5]
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. Add brake fluid, bleed the brakes, and inspect for leakage after the installation
has been completed..
1
Brake pipe
2
Clip
3
...
Seat Belt Inspection
Belt
1. Verify that the belt is installed properly with no twists or kinks.
2. Verify that there is no damage to the seat belt and no deformation of the
metal fittings.
If there is any malfunction, replace the seat belt.
ELR
Except 5HB (rear center seat belt)
1. Verify tha ...
Inner Garnish Removal/Installation
1. Disconnect the negative battery cable..
2. Pull the inner garnish in the direction of the arrow shown in the figure and
remove it while detaching clips and tab.
CAUTION:
When pulling out the inner garnish, be careful not to damage the tab.
3. Disconnect the front tweeter c ...
