Sensor Output Value Inspection
CAUTION:
Resistance inspection using other testers may cause damage to the ABS wheel-speed sensor internal circuit. Be sure to use the M-MDS to inspect the ABS wheel-speed sensor.
1. Switch the ignition to off.
2. Connect the M-MDS to the DLC-2.
3. Select the following PIDs using the M-MDS:
WSPD_LF
(LF wheel-speed sensor)
WSPD_RF
(RF wheel-speed sensor)
4. Start the engine and drive the vehicle.
5. Verify that the display of the M-MDS shows the same value as the speedometer.
If there is any malfunction, replace the front ABS wheel-speed sensor.
Installation Visual Inspection
1. Inspect for the following:
If there is any malfunction, replace the part.
a. Excessive play of the front ABS wheel-speed sensor
b. Deformation of the front ABS wheel-speed sensor
Clearance Inspection
Preparation prior to inspection
1. Remove the front ABS wheel-speed sensor..
2. Remove the wheel hub, steering knuckle component..
3. Install the front ABS wheel-speed sensor to the removed the wheel hub, steering knuckle component, and tighten to the specified torque.
4.0—6.0 N·m {41—61 kgf·cm, 36—53 in·lbf}
Clearance Inspection
1. Measure the gap between the front ABS sensor rotor and the front ABS wheel-speed sensor using a feeler gauge.
If not within the specification, verify the following items and repair or replace if necessary.
Is there deformation or damage to the front ABS sensor rotor?
Is there deformation or damage to the front ABS wheel speed sensor?
Is there foreign material adhering?
2.1 mm {0.082 in} or less
Servicing after inspection
1. Remove the front ABS wheel-speed sensor from the wheel hub, steering knuckle component.
2. Install the wheel hub, steering knuckle component..
3. Install the front ABS wheel-speed sensor..
4. Inspect the front wheel alignment..
Headlight Auto Leveling System Initialization
CAUTION:
If the headlight auto leveling initial setting is not stored correctly, the
headlight auto leveling system may not operate normally. To store the initial
setting correctly, perform the initial setting with the vehicle under the following
conditions:
No occupant ...
Battery
WARNING
Wash hands after handling the battery and related accessories:
Battery posts, terminals and related accessories contain lead and lead
compounds,
chemicals known to the State of California to cause cancer and
reproductive harm.
Read the following
precautions ...
Rear Door Speaker Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the rear door trim..
3. Disconnect the connector.
Without Bose®
With Bose®
4. Remove the screw.
5. Remove the rear door speaker in the direction of the arrow shown in the figure.
Without Bose®
With Bose®
6. Install i ...