Mazda 3 Service Manual: Front Brake (Disc) Removal/Installation [Mzr 2.0, Skyactiv G 2.0, Mzr 2.5]
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. After installation, pump the brake pedal a few times and verify that the brakes do not drag.
|
1 |
Brake hose (See Brake Hose Installation Note.) |
|
2 |
Retaining clip (See Retaining Clip Installation Note.) |
|
3 |
Cap |
|
4 |
Bolt |
|
5 |
Caliper |
|
6 |
Boot |
|
7 |
Disc pad (See Disc Pad Installation Note.) |
|
8 |
Bolt |
|
9 |
Mounting support |
|
10 |
Disc plate |
Disc Pad Installation Note
1. Clean the exposed area of the piston.
2. Push the piston in using the SST
.
3. Install the disc pad (outer side) to the mounting support.
4. Install the disc pad (inner side) to the caliper.
Retaining Clip Installation Note
1. Temporarily install the retaining clip to the caliper and mounting support as shown in the figure.
2. Secure the retaining clip so that part A does not slip off from the caliper while installing part B to the mounting support.
3. Verify that the retaining clip is securely installed to the caliper and the mounting support.
Brake Hose Installation Note
1. Install the brake hose to the caliper.
2. Tighten the flare nut while holding the brake hose at point A with a spanner or equivalent.
3. Verify that the brake hose is not twisted.
Front Brake (Disc) Inspection
Brake Judder Repair Hints
Description
1. Brake judder concern has the following 3 characteristics:
Steering wheel vibration
1. The steering wheel vibrates in the rotation direction. This characte ...
Front Brake (Disc) Removal/Installation [Mzr 2.3 Disi Turbo]
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. After installation, pump the brake pedal a few times and verify that the brakes
do not drag.
...
Other materials:
Fuel Requirements
Vehicles with catalytic converters or oxygen sensors must use ONLY UNLEADED
FUEL,
which will reduce exhaust emissions and keep spark plug fouling to a minimum.
This vehicle will perform best with fuel listed in the table.
* U.S. federal law requires that octane ratings be posted on gasoli ...
Restraints SST [Two Step Deployment Control System]
49 H066 002
Deployment tool
49 D066 002
Adapter harness
49 L066 002
Adapter harness
49 G066 003
Adapter harness
49 N088 0A0
Fuel and Therm ...
Air Filter Removal/Installation [Mzr 2.0, Mzr 2.5]
Except for Mexico
1. Remove the fuel-filler pipe protector..
2. Remove in the order indicated in the table.
1
Evaporative hose
2
Air filter
3. Install in the reverse order of removal. ...
