1. To access the glass installation bolt, position the front door glass so that the distance from the top of the front door glass to the upper part of the front beltline molding is approx. 80 mm {3.1 in}
.
2. Disconnect the negative battery cable..
3. Remove the following parts:
a. Inner garnish.
b. Front door trim.
c. Front door speaker.
d. Front door glass.
e. Front door module panel.
4. Remove the service hole cover.
5. Remove the tab, then remove the door lock-link bracket.
6. Remove the service hole cover.
7. Remove the screw from the service hole.
NOTE:
The screw cannot be removed because of the stopper.
8. Lift the clip in the direction of the arrow (1), and pull out the key rod in the direction of the arrow (2).
9. Press the tab on the front outer handle bracket in the direction of the arrow.
10. Maintaining the condition in Step 9, remove the front key cylinder.
11. Using a tape-wrapped fastener remover, press up the collar cap in the direction of the arrow shown in the arrow, press aside the front door key cylinder tabs (1), and remove the collar cover from the front door key cylinder.
12. Install in the reverse order of removal.
No.6 Bsm Indicator Light Flashes While Not Under Bsm Indicator Light Flashing
Conditions (No Combination Switch Operation (Turn Signal Switch)) [Blind Spot Monitoring
(Bsm)]
6
BSM indicator light flashes while not under BSM indicator light-flashing
conditions (no combination switch operation (turn signal switch)
Description
The BSM indicator light flashes despite not satisfying the BSM indicator
l ...
Mute
The microphone can be muted during a
call.
Press the talk button with a short press.
Say: [Beep] “Mute”
Prompt: “Microphone muted”
Canceling mute
Press the talk button with a short press.
Say: [Beep] “Mute off”
Prompt: “Microphone unmuted”
Transferring a Call from Hands-
Free ...
Seat Weight Sensor Control Module Removal/Installation [Two Step Deployment
Control System]
CAUTION:
When the seat weight sensor control module is replaced with a new one, perform
the seat weight sensor calibration using the M–MDS..
1. Switch the ignition to off.
2. Disconnect the negative battery cable and wait for 1 min or more..
3. Disconnect the connectors.
...