1. To access the glass installation bolt, position the front door glass so that the distance from the top of the front door glass to the upper part of the front beltline molding is approx. 80 mm {3.1 in}
.
2. Disconnect the negative battery cable..
3. Remove the following parts:
a. Inner garnish.
b. Front door trim.
c. Front inner handle.
d. Front door speaker.
e. Front door glass.
f. Front door module panel.
4. Remove the service hole cover (with front door key cylinder).
5. Remove the tab, then remove the door lock-link bracket (with front door key cylinder).
6. Disconnect the key rod from the front outer handle bracket.
7. Remove the screw.
8. Detach the clips.
9. Press down the rod holder of the front door latch and lock actuator in the direction of the arrow.
10. Maintaining the condition in Step 9, remove the front door latch and lock actuator.
11. Install in the reverse order of removal.
Fuel Requirements
Vehicles with catalytic converters or oxygen sensors must use ONLY UNLEADED
FUEL,
which will reduce exhaust emissions and keep spark plug fouling to a minimum.
This vehicle will perform best with fuel listed in the table.
* U.S. federal law requires that octane ratings be posted on gasoli ...
Limitations to SRS Air Bag
In severe collisions such as those described previously in "SRS Air Bag
Deployment
Criteria", the applicable SRS air bag equipment will deploy. However, in some
accidents,
the equipment may not deploy depending on the type of collision and its
severity.
Limitations to front/near ...
Fuel Filler Cap Inspection [Mzr 2.0, Mzr 2.5]
Leakage Inspection
1. Perform the following SST (Evaporative Emission System Tester 134-01049A)
self-test:
NOTE:
If the tester does not work correctly during self-test, refer to the tester
operators manual for more detailed procedures.
a. Verify that the gas cylinder valve is c ...