4SD
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Front seat (LH).
b. Front scuff plate (LH).
c. Rear scuff plate.
d. B-pillar lower trim.
e. Rear seat cushion.
f. Rear seat back.
g. Tire house trim.
h. Trunk end trim.
i. Trunk side trim (RH).
j. Fuel-filler lid opener.
k. Fuel-filler lid opener lever.
3. Remove the bolts and nut.
4. Remove the bracket.
5. Remove the fuel-filler lid opener cable from clips A and B.
6. Remove the fuel-filler lid opener cable from clips C.
7. Remove the fuel-filler lid opener cable from clips D and E.
8. Remove the fuel-filler lid opener cable from clips F.
9. Install in the reverse order of removal.
5HB
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Front seat (LH).
b. Front scuff plate (LH).
c. Rear scuff plate.
d. B-pillar lower trim.
e. Rear seat cushion.
f. Rear seat back.
g. Tire house trim.
h. Trunk side upper trim (RH).
i. Trunk end trim.
j. Trunk side trim (RH).
k. Fuel-filler lid opener.
l. Fuel-filler lid opener lever.
3. Remove the bolts and nut.
4. Remove the bracket.
5. Remove the fuel-filler lid opener cable from clips A and B.
6. Remove the fuel-filler lid opener cable from clips C.
7. Remove the fuel-filler lid opener cable from clips D and E.
8. Remove the fuel-filler lid opener cable from clips F.
9. Install in the reverse order of removal.
Ignition Coil Removal/Installation [Mzr 2.3 Disi Turbo]
1. Remove the battery cover..
2. Disconnect the negative battery cable..
3. Remove the charge air cooler..
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
1
Connector
2
Ignition coil
...
Opening the Hood
With the vehicle parked, pull the
release handle to unlock the hood.
Insert your hand into the hood opening,
slide the latch lever to the right, and lift
up the hood.
NOTE
The lever is located a little to the left of
center when facing the vehicle.
Grasp the support r ...
Antenna Feeder No.3 Inspection
4SD (With Audio System (With Display))
1. Disconnect the negative battery cable..
2. Remove the rain sensor cover. (Vehicles with auto light/wiper system).
3. Disconnect the rain sensor connector. (Vehicles with auto light/wiper system)
4. Partially peel back the seaming welts.
5. Remove t ...