Mazda 3 Service Manual: Fuel Gauge Sender Unit Inspection
MZR 2.3 DISI Turbo, SKYACTIV-G 2.0
NOTE:
-
The fuel gauge sender unit is integrated with the fuel pump unit.
1. Disconnect the negative battery cable..
2. Remove the rear seat cushion..
3. Remove the fuel pump unit..
4. Verify that the resistance between terminals A and C of the fuel gauge sender unit based on the height of the float as shown in the figure.
-
If they are not as shown in the figure, replace the fuel pump unit.
|
Float height (mm {in}) |
Resistance (ohms) |
|
165.6 {6.520} |
9.5—12.5 |
|
159.3 {6.272} |
20.0 |
|
130.1 {5.122} |
109.4 |
|
91.3 {3.59} |
194.8—222.2 |
|
52.2 {2.06} |
307.6 |
|
25.7 {1.01} |
400.0 |
|
20.0 {0.787} |
414.5—405.5 |
MZR 2.0, MZR 2.5
NOTE:
-
The fuel gauge sender unit is integrated with the fuel pump unit.
1. Disconnect the negative battery cable..
2. Remove the rear seat cushion..
3. Remove the fuel pump unit..
4. Verify that the resistance between terminals B and D of the fuel gauge sender unit based on the height of the float as shown in the figure.
-
If they are not as shown in the figure, replace the fuel pump unit.
|
Float height (mm {in}) |
Resistance (ohms) |
|
168.5 {6.634} |
18—22 |
|
130.1 {5.122} |
107.2—111.6 |
|
91.3 {3.59} |
206—211 |
|
52.2 {2.06} |
304.6—310.6 |
|
40.6 {1.60} |
333.5—339.5 |
|
12.1 {0.476} |
396.8—403.2 |
Air Bleeding
CAUTION:
If the strainer is removed, impurities may penetrate the power steering system
and damage it. To prevent this, always bleed air with the strainer installed.
Do not ma ...
Fuel Gauge Sender Unit Removal/Installation
MZR 2.0, MZR 2.5
NOTE:
Fuel pump unit cannot be disassembled.
1. Remove the fuel gauge sender unit..
MZR 2.3 DISI Turbo
NOTE:
Fuel pump unit cannot be disassembled.
1. ...
Other materials:
Overheating
If the high engine coolant temperature
warning light illuminates, the vehicle loses
power, or you hear a loud knocking or
pinging noise, the engine is probably too
hot.
WARNING
Switch the ignition to off and make
sure the fan is not running before
attempting to work near the co ...
Parking Brake Lever Removal/Installation
1. Remove the following parts:
a. Upper panel.
b. Shift knob (MTX).
c. Selector lever knob (ATX).
d. Shift panel.
e. Side wall.
f. Console.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
4. After installation, inspect the parking brake le ...
Steering Gear And Linkage Assembly
CAUTION:
To prevent damage to the steering gear, secure it to the vise using a copper
plate or clean cloth.
1. Assemble in the order indicated in the table.
1
Gear housing
2
Mounting rubber
(See Mounting Rubber Assembly No ...
