WARNING:
Fuel is very flammable liquid. If fuel spills or leaks from the pressurized fuel system, it will cause serious injury or death and facility breakage. Fuel can also irritate skin and eyes. To prevent this, always complete the “Fuel Line Safety Procedure”, while referring to the “BEFORE SERVICE PRECAUTION”.
A person charged with static electricity could cause a fire or explosion, resulting in death or serious injury. Before draining fuel, make sure to discharge static electricity by touching the vehicle body.
NOTE:
The rollover valve and the fuel shut-off valve or check valve (two-way) built into the fuel tank and fuel tank leakage are inspected in this inspection.
1. Complete the “BEFORE SERVICE PRECAUTION”..
2. Remove the battery cover..
3. Disconnect the negative battery cable..
4. Remove the rear seat cushion..
5. Disconnect the fuel pump unit connector..
6. Remove the fuel tank and the fuel pump unit as a single unit..
7. Perform the following procedure to verify the fuel tank airtightness.
a. Plug the fuel pump unit pipe, ports B and C.
b. Apply a pressure of 3 kPa {23 mmHg, 0.9 inHg}
to port A and wait for a while.
c. Verify that there is no air flow leakage from the fuel tank.
If there is air flow, replace the fuel tank..
8. Plug the fuel pump unit pipe and port B.
9. Level the fuel tank.
10. Apply a pressure of 3 kPa {23 mmHg, 0.9 inHg}
to port A and wait for a while.
11. With the pressure still applied, verify that there is air flow port C and the pressure is 0—3 kPa {0—23 mmHg, 0—0.9 inHg}
.
If there is no air flow, replace the fuel tank..
12. Apply a pressure of -0.5 kPa {-3.8 mmHg, -0.1 inHg}
to port A and wait for a while.
13. With the pressure still applied, verify that there is air flow port C and the pressure is -0.5—0 kPa {-3.8—0 mmHg, -0.1—0 inHg}
.
If there is no air flow, replace the fuel tank..
If there is air flow, place the fuel tank upside down.
14. Apply a pressure to port A and wait for a while.
15. With the pressure still applied, verify that there is no air flow from port C.
If there is air flow, replace the fuel tank..
Rear Door Speaker Inspection
1. Disconnect the negative battery cable..
2. Remove the rear door trim..
3. Remove the rear door speaker..
4. Verify the resistance between the rear door speaker terminals.
If not within the specification, replace the rear door speaker.
Resistance
Without Bose ...
Variable Valve Timing Actuator Removal/Installation [Mzr 2.3 Disi Turbo]
WARNING:
Fuel vapor is hazardous. It can very easily ignite, causing serious injury
and damage. Always keep sparks and flames away from fuel.
Fuel line spills and leakage are dangerous. Fuel can ignite and cause serious
injuries or death and damage. Fuel can also irritate skin ...
Passenger Side Air Bag Module Removal/Installation [Standard Deployment Control
System]
WARNING:
Handling the air bag module improperly can accidentally deploy the air bag
module, which may seriously injure you. Read the air bag system service warnings
and cautions before handling the air bag module..
NOTE:
When replacing the passenger-side air bag module af ...