Mazda 3 Service Manual: Fuses & Junction Blocks

Battery Removal/Installation [Skyactiv G 2.0]

1. Remove in the order indicated in the table. 2. Install in the reverse order of removal. 1 Battery cover (See Battery Cover Removal Note.) (See Battery Cover In ...

Front Fog Light Relay Removal/Installation

1. Disconnect the negative battery cable.. 2. Remove the front mudguard.(RH). 3. Remove the front fog light relay case. 4. Remove the cover. 5. Remove the front fog light relay. 6. Insta ...

Other materials:

Center Roof Antenna Removal/Installation
4SD 1. Disconnect the negative battery cable.. 2. Remove the rain sensor cover. (Vehicles with auto light/wiper system). 3. Disconnect the rain sensor connector. (Vehicles with auto light/wiper system) 4. Partially peel back the seaming welts. 5. Remove the following parts: a. Sunroof se ...

Slide Motor Inspection
1. Remove the battery cover.. 2. Disconnect the negative battery cable and wait 1 min or more.. 3. Disconnect the slide motor connector. 4. Apply battery positive voltage to the slide motor terminals and inspect the slide motor operation If not as specified, replace the front sea ...

Transaxle Fluid Temperature (Tft) Sensor Inspection [FS5 A EL]
CAUTION: Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the connector when disconnecting it. On-Vehicle Inspection 1. Perform the following procedures. a. Remove the battery cover.. b. ...