Mazda 3 Service Manual: General
- Auto Leveling Sensor Inspection
- Auto Leveling Sensor Removal/Installation
- Cargo Compartment Light Bulb Removal/Installation
- Cargo Compartment Light Inspection
- Cargo Compartment Light Removal/Installation
- Ignition Key Illumination Removal/Installation
- Inboard Light Removal/Installation
- Indirect Illumination Removal/Installation
- Lighting System Personalization Features Setting Procedure
- Rear Turn Light Bulb Removal/Installation
- Side Turn Light Inspection
- Side Turn Light Removal/Installation
- Vanity Mirror Illumination Inspection
Lighting & Horn
...
Auto Leveling Sensor Inspection
1. Disconnect the negative battery cable..
2. Remove the auto leveling sensor..
3. Connect the three dry cell batteries (1.5 V) in a series.
4. Connect auto leveling sensor terminal A to the ...
Other materials:
Picture Quality Adjustment
WARNING
Always adjust the picture quality of the rear view monitor while the
vehicle is stopped:
Do not adjust the picture quality of the rear view monitor while driving
the vehicle.
Adjusting the picture quality of the rear view monitor such as
brightness, contrast, colo ...
Checking Tire Pressure
When you check the air pressure, make sure the tires are cold —meaning
they are not hot
from driving even a mile.
Remove the cap from the valve on one tire.
Firmly press a tire gauge onto the valve.
Add air to achieve recommended air pressure.
If you overfill the tire, release air by ...
Body Control Module (Bcm) Removal/Installation
CAUTION:
When replacing the BCM, the configuration procedure must be performed before
removing the BCM. Replacing the BCM without performing the configuration procedure
will result in system malfunction.
ATX
1. Perform the BCM configuration when replacing it..
2. Disconnect t ...
