1. Fully close the glass panel.
2. Measure the gap and height between the glass panel and body.
If not as specified, loosen the glass panel installation screws and reposition the glass panel.
a: -2.4—0.2 mm {-0.09—0.01 in}
b: 0 mm {0 in}
c: -2.2—0.4 mm {-0.08—0.01 in}
d: 0 mm {0 in}
a: -2.3—0.3 mm {-0.09—0.01 in}
b: 0 mm {0 in}
c: -2.3—0.3 mm {-0.09—0.01 in}
d: 0 mm {0 in}
3. Tighten the installation screws.
4. Insert a plastic card between the weatherstrip and the body of the vehicle. Verify that the sunroof is shut tightly (there is resistance when the plastic card is moved).
If the sunroof is not shut tightly, readjust by performing Steps 2 and 3.
Camshaft Position (CMP) Sensor Removal/Installation [Mzr 2.0, Mzr 2.5]
CAUTION:
When replacing the CMP sensor, make sure there is no foreign material on
it such as metal shavings. If it is installed with foreign material, the sensor
output signal will malfunction resulting from fluctuation in magnetic flux and
cause a deterioration in engine control.
...
Dashboard Disassembly/Assembly
1. Remove the ventilator grilles..
2. Remove the Passenger-side air bag module..
3. Disassemble in the order indicated in the table.
4. Assemble in the reverse order of disassembly.
1
Wiring harness
2
Screw
3
...
Joint Shaft Disassembly [Mzr 2.0, Mzr 2.5]
1. Disassemble in the order indicated in the table.
1
Joint shaft component
.
2
Bearing
.
3
Dust seal (LH)
4
Joint shaft
5
Dust seal (RH)
...