Mazda 3 manuals

Mazda 3 Service Manual: Global Positioning System (Gps) Antenna Removal/Installation

Mazda 3 Service Manual / Accessories / Electronics / Navigation / Global Positioning System (Gps) Antenna Removal/Installation

With Audio Unit (Without Display)

1. Disconnect the negative battery cable..

2. Remove the following parts:

a. Upper column cover.

b. Instrument cluster.

3. Remove in the order indicated in the table.



1

Connector

2

Screw

3

Clip

4

GPS antenna


4. Install in the reverse order of removal.

With Audio Unit (With Display)

1. Disconnect the negative battery cable..

2. Remove the following parts:

a. Upper column cover.

b. Instrument cluster.

3. Remove in the order indicated in the table.



1

Connector

2

Screw

3

GPS antenna


4. Install in the reverse order of removal.

Car Navigation Unit Removal/Installation
With Audio Unit (Without Display) NOTE: Car-navigation unit is integrated with the multi information display. 1. Refer to MULTI INFORMATION DISPLAY REMOVAL/INSTALLATION. With Audio U ...

Gps Antenna Feeder Inspection
With Audio Unit (Without Display) 1. Verify that the continuity is as indicated in the table. If not as indicated in the table, replace the GPS antenna feeder. With Audio Unit ( ...

Other materials:

Rain Sensor Removal/Installation
1. Disconnect the negative battery cable.. 2. Spread open the rain sensor cover in the direction of the arrows and disengage tabs A to remove it. 3. Disconnect the rain sensor connector. 4. Slide rain sensor tab B in the direction of the arrow shown in the figure and detach tab B. ...

Auto Lock/Unlock Function
WARNING Do not pull the inner handle on a front door: Pulling the inner handle on a front door while the vehicle is moving is dangerous. Passengers can fall out of the vehicle if the door opens accidentally , which could result in death or serious injury. When ...

Roof Molding Removal
1. Insert a fastener remover in the position shown in the figure. 2. Rotate the flathead screwdriver in the direction of the arrow (1) shown in the figure and remove the roof molding from the T-stud (figure A). 3. Rotate the roof molding in the direction of the arrow (2) shown in the figure, ...

© 2016-2024 Copyright www.mazda3tech.com