Mazda 3 manuals

Mazda 3 Service Manual: Gps Antenna Feeder Removal/Installation

Mazda 3 Service Manual / Accessories / Electronics / Navigation / Gps Antenna Feeder Removal/Installation

With Audio Unit (Without Display)

NOTE:

1. Refer to MULTI INFORMATION DISPLAY REMOVAL/INSTALLATION.

With Audio Unit (With Display)

NOTE:

1. Refer to ANTENNA FEEDER NO.4 REMOVAL/INSTALLATION.

Gps Antenna Feeder Inspection
With Audio Unit (Without Display) 1. Verify that the continuity is as indicated in the table. If not as indicated in the table, replace the GPS antenna feeder. With Audio Unit ( ...

No.1 Car Navigation System Does Not Start Operation [Car Navigation System]
1 Even if the NAVI mode is selected, the car-navigation system screen does not display. Possible DTC — POSSIBLE CAUSE ...

Other materials:

Timing Chain Removal/Installation [Skyactiv G 2.0]
WARNING: A hot engine can cause severe burns. Turn off the engine and wait until it is cool before servicing. CAUTION: If the camshaft is rotated with the timing chain removed and the piston at the top dead center position, the valve may contact the piston and the engine ...

Opening the Hood
With the vehicle parked, pull the release handle to unlock the hood. Insert your hand into the hood opening, slide the latch lever to the right, and lift up the hood. NOTE The lever is located a little to the left of center when facing the vehicle. Grasp the support r ...

Vacuum Hose Removal/Installation [Mzr 2.3 Disi Turbo]
1. Remove the charge air cooler cover.. 2. Remove the charge air cooler.. 3. Insert a thin flathead screwdriver at the point indicated by the arrow in the figure, push the ring down and disconnect the vacuum hose from the intake manifold. 4. Remove the vacuum hose from the vacuum hose c ...

© 2016-2024 Copyright www.mazda3tech.com