Mazda 3 Owners Manual: Hazard Warning Flasher

Mazda 3 Owners Manual / When Driving / Switches and Controls / Hazard Warning Flasher

The hazard warning lights should always be used when you stop on or near a roadway in an emergency.

Mazda 3. Hazard Warning Flasher

The hazard warning lights warn other drivers that your vehicle is a traffic hazard and that they must take extreme caution when near it.

Depress the hazard warning flasher and all the turn signals will flash. The hazard warning indicator lights in the instrument cluster flash simultaneously.

NOTE

The turn signals do not work when the hazard warning lights are on.
Check local regulations about the use of hazard warning lights while the vehicle is being towed to verify that it is not in violation of the law.

Rear Window Defogger

The rear window defogger clears fog from the rear window. The ignition must be switched ON to use the defogger. Press the switch to turn on the rear window defogger. The rear window defogger ...

HomeLink Wireless Control System*

NOTE HomeLink and HomeLink house are registered trademarks of Johnson Controls. The HomeLink system replaces up to 3 hand-held transmitters with a single built-in component in the auto-dimming ...

Other materials:

Ignition Switch
Push Button Start Positions The system operates only when the key is within operational range. Each time the push button start is pressed, the ignition switches in the order of off, ACC, and ON. Pressing the push button start again from ON switches the ignition off. NOTE The engine ...

Active Adaptive Shift (AAS)
Active Adaptive Shift (AAS) automatically controls the transaxle shift points to best suit the road conditions and driver input. This improves driving feel. The transaxle may switch to AAS mode when driving up and down slopes, cornering, driving at high elevations, or depressing the accelerat ...

Front ABS Wheel Speed Sensor Inspection
Sensor Output Value Inspection CAUTION: Resistance inspection using other testers may cause damage to the ABS wheel-speed sensor internal circuit. Be sure to use the M-MDS to inspect the ABS wheel-speed sensor. 1. Switch the ignition to off. 2. Connect the M-MDS to the DLC-2. ...