Mazda 3 Service Manual: Headlight Leveling Actuator Inspection
NOTE:
-
Headlight leveling actuator are integrated with the front combination light.
-
For the actuator inspection of the headlight auto leveling system, perform the headlight leveling actuator operation inspection..
1. Measure the voltage at each terminal is as indicated in the Terminal Voltage Lists.
-
If the voltage is not as specified in the Terminal Voltage Lists, inspect the parts under “Inspection item (s)”.
-
If the system does not work properly even though the parts or related wiring harnesses do not have any malfunction, replace the front combination light.
Terminal Voltage List (Reference)
|
Terminal
|
Signal
|
Connection
|
Test condition
|
Voltage (V)/Continuity
|
Action
|
|
|
F |
Headlight leveling actuator signal |
Headlight leveling switch |
Light switch at HEAD position |
Switch position 0 position |
approx. 10.5 |
|
|
Switch position 1 position |
approx. 9.2 |
|||||
|
Switch position 2 position |
approx. 6.2 |
|||||
|
Switch position 3 position |
approx. 4.9 |
|||||
|
I |
Headlight leveling actuator power supply |
Headlight relay (LO) |
Light switch at HEAD position |
B+ |
|
|
|
Light switch at OFF position |
1.0 or less |
|||||
|
L |
GND |
Headlight leveling switch Body ground |
Under any condition |
1.0 or less |
|
|
Headlight Bulb Removal/Installation
Halogen Type
Low-beam
1. Disconnect the negative battery cable..
2. Disconnect the connector.
3. Remove the cover.
4. Remove the adaptor.
5. Remove the headlight bulb (LO).
CAUTION ...
High Mount Brake Light Bulb Removal/Installation
4SD
1. Disconnect the negative battery cable..
2. Remove the trunk lid trim..
3. Remove in the order indicated in the table.
1
Connector
2
...
Other materials:
On/Off Solenoid Removal/Installation [Fw6 A EL]
WARNING:
A hot transaxle and ATF can cause severe burns. Turn off the engine and wait
until they are cool.
Always wear protective eye wear when using the air compressor. If the air
compressor is used, any particles of dirt or soiling could spatter and get into
the eyes.
...
Audio Control Switch Operation
Without Bluetooth ® Hands-Free
With Bluetooth ® Hands-Free
Adjusting the Volume
To increase the volume, press up the
volume switch ( +).
To decrease the volume, press down the
volume switch ( -).
Seek Switch
AM/FM radio
Press the seek switch ( ,
). The radio
switches to the ...
Fuel Gauge Sender Unit Removal/Installation
MZR 2.0, MZR 2.5
NOTE:
Fuel pump unit cannot be disassembled.
1. Remove the fuel gauge sender unit..
MZR 2.3 DISI Turbo
NOTE:
Fuel pump unit cannot be disassembled.
1. Remove the fuel gauge sender unit..
SKYACTIV-G 2.0
NOTE:
Fuel pump unit cannot be disasse ...
