Mazda 3 Owners Manual: Heating
- Set the mode selector dial to the
position. - Set the air intake selector to the outside air position.
- Set the temperature control dial to the hot position.
- Set the fan control dial to the desired speed.
- If dehumidified heating is desired, turn on the air conditioner.
NOTE
- If the windshield fogs up easily, set the
mode selector dial to the
position. - If cooler air is desired at face level, set
the mode selector dial at the
position and adjust the temperature control dial to maintain maximum comfort. - The air to the floor is warmer than air to the face (except when the temperature control dial is set at the extreme hot or cold position).
Control Switches
Temperature control dial
This dial controls temperature. Turn it
clockwise for hot and counterclockwise
for cold.
NOTE
When the mode is set to or
with the
fan control dial in a position oth ...
Cooling (With air conditioner)
Set the mode selector dial to the
position.
Set the temperature control dial to the
cold position.
Set the fan control dial to the desired
speed.
Turn on the air conditioner by press ...
Other materials:
Plastic Part Maintenance
When cleaning the plastic lenses of the
lights, do not use gasoline, kerosene,
rectified spirit, paint, thinner, highly
acidic detergents, or strongly alkaline
detergents. Otherwise, these chemical
agents can discolor or damage the
surfaces resulting in a significant loss
in functio ...
Rear Upper Arm Removal/Installation
1. When working on the right side of the vehicle, disconnect the canister vent
(CV) solenoid valve from the rear crossmember. (MZR 2.0 (Except Mexico), SKYACTIV-G
2.0, MZR 2.3 DISI Turbo, MZR 2.5 (Except Mexico))
2. Remove in the order indicated in the table.
3. Install in the reverse or ...
Wastegate Actuator Inspection [Mzr 2.3 Disi Turbo]
1. Remove the air hose and air duct..
2. Disconnect the hose from the wastegate actuator.
3. Plug the wastegate actuator as shown in the figure.
4. Connect the vacuum pump to the port
5. Raise the pressure slowly and take a measurement of the pressure when the
rod stroke is 1.5 mm {0.0 ...
