Mazda 3 manuals

Mazda 3 Service Manual: High Mount Brake Light Removal/Installation

Mazda 3 Service Manual / Body / Lighting & Horn / Exterior / High Mount Brake Light Removal/Installation

4SD

1. Disconnect the negative battery cable..

2. Remove the trunk lid trim..

3. Disconnect the connector.


4. Remove the nuts.

5. While pressing the tabs shown in the figure, pull the high-mount brake light outward and remove it.


6. Remove the high-mount brake light.

7. Install in the reverse order of removal.

5HB

Except Mazdaspeed3

1. Disconnect the negative battery cable..

2. Remove the liftgate upper trim..

3. While pressing the tabs shown in the figure, pull the high-mount brake light outward and remove it.


4. Remove the high-mount brake light socket.


5. Remove the high-mount brake light.

6. Install in the reverse order of removal.

Mazdaspeed3

1. Disconnect the negative battery cable..

2. Remove the liftgate upper trim..

3. Remove the rear spoiler..

4. Remove the screws shown in the figure.


5. Set the pin aside and remove the cover.


6. Remove the screws shown in the figure.


7. Pull out the wiring harness from the rear spoiler.


8. Remove the high-mount brake light.

9. Install in the reverse order of removal.

High Mount Brake Light Disassembly/Assembly
4SD 1. Disconnect the negative battery cable.. 2. Remove the trunk lid trim.. 3. Remove the high-mount brake light.. 4. Remove the high-mount brake light outer lens. 5. Remove the high-mo ...

License Plate Light Bulb Removal/Installation
1. Disconnect the negative battery cable.. 2. Insert a tape-wrapped fastener remover to the position shown in the figure, release the tabs, and remove the lens. 3. Remove the license plate l ...

Other materials:

Tire Inflation Pressure
WARNING Always infl ate the tires to the correct pressure: Overinfl ation or underinfl ation of tires is dangerous. Adverse handling or unexpected tire failure could result in a serious accident. Refer to Tires on . Use only a Mazda-genuine tire valve cap: Use ...

Intake Manifold Vacuum Inspection [Mzr 2.0, Mzr 2.5]
1. Disconnect the evaporative hose (purge solenoid valve side) and install the vacuum gauge.. 2. Verify that the intake air hoses are installed securely. 3. Warm up the engine. 4. Measure the intake manifold vacuum while idling (no load) using the vacuum gauge. If not within the sp ...

Front Stabilizer Control Link Inspection
1. Remove the front stabilizer control link from the vehicle.. (See FRONT STABILIZER REMOVAL/INSTALLATION [MZR 2.3 DISI Turbo] 2. Inspect for bending or damage. If there is any malfunction, replace the stabilizer control link. 3. Rotate the ball joint stud 10 times and shake it side to side ...

© 2016-2025 Copyright www.mazda3tech.com