Gap Adjustment
1. Verify that the gap between the hood and the body is within the specification.
a: -2.8—0.8 mm {-0.11—0.03 in}
b: –1.2—1.2 mm {–0.047—0.0.47 in}
2. Disconnect the negative battery cable..
3. Remove the following parts:
a. Front bumper.
b. Front combination light.
c. Front fender molding.
d. Side step molding.
e. Front fender panel.
4. Loosen the hood hinge installation bolts and adjust the hood.
5. Tighten the bolts..
6. Install the following parts:
a. Front fender panel.
b. Side step molding.
c. Front fender molding.
d. Front combination light.
e. Front bumper.
7. Connect the negative battery cable..
Height Difference Adjustment
1. Verify that the height difference between the hood and the body is within the specification.
a: 3.0—6.0 mm {0.12—0.23 in}
b: 1.9—5.1 mm {0.08—0.20 in}
c: 2.5—4.9 mm {0.10—0.19 in}
2. Turn the stop rubber to adjust the height of the hood.
Pilot Bearing Inspection [A26 M R]
CAUTION:
Secure the steering wheel using tape or a cable to prevent the steering shaft
from rotating after disconnecting the steering shaft. If the steering wheel
rotates after the steering shaft and the steering gear and linkage are disconnected,
the internal parts of the clock spr ...
Air Bleeding
CAUTION:
If the strainer is removed, impurities may penetrate the power steering system
and damage it. To prevent this, always bleed air with the strainer installed.
Do not maintain the steering wheel fully turned for 5 s or more. The oil
temperature could rise and damage ...
System
The system operates only when the driver
is in the vehicle or within operational
range while the key is being carried.
NOTE
When the battery power is low, or in
places where there are high-intensity radio
waves or noise, the operational range
may become narrower or the system may
not operate ...