Mazda 3 Service Manual: Horn Inspection

Mazda 3 Service Manual / Body / Horn / Horn Inspection

1. Disconnect the negative battery cable..

2. Remove the front bumper..

3. Remove the horn..

4. Apply battery positive voltage and connect the ground as shown in the figure and verify the horn beeper sound operation.

If the beep sound cannot be verified, replace the horn.

Horn Removal/Installation

1. Disconnect the negative battery cable.. 2. Remove the front bumper.. 3. Disconnect the connector. 4. Remove the bolt. 5. Remove the horn. 6. Install in the reverse order of removal. ...

Other materials:

Front Fog Light Removal/Installation
Except Mazdaspeed3 1. Disconnect the negative battery cable.. 2. Remove the front bumper.. 3. Pull the wiring harness from the hook in the direction of the arrow shown in the figure and remove it. 4. Disconnect the connector. 5. Pull the wiring harness in the direction of the arrow (2 ...

Cowl Grille Removal/Installation
1. Remove the windshield wiper arm and blade.. 2. Remove the fastener A. 3. Pull the front fender molding in the direction of the arrow shown in the figure and remove it while remove the tab B and tab C. 4. Disconnect the windshield washer hose from the joint pipe A.. 5. Remove the fas ...

Clutch Master Cylinder Removal/Installation [C66 M R]
CAUTION: Secure the steering wheel using tape or a cable to prevent the steering shaft from rotating after disconnecting the steering shaft. If the steering wheel rotates after the steering shaft and the steering gear and linkage are disconnected, the internal parts of the clock spr ...