Mazda 3 Owners Manual: How to use AUX mode (Type B)

Mazda 3 Owners Manual / Interior Features / Audio System / AUX/USB/iPod mode / How to use AUX mode (Type B)

Select the icon on the home screen to display the Entertainment screen.
Select to switch to the AUX mode. The following icons are displayed in the lower part of the center display.

Icon	Function
	Displays the Entertainment menu. Use to switch to a different audio source.
	Displays sound settings to adjust audio quality level. Refer to Volume/Display/Sound Controls on .

NOTE

If a device is not connected to the auxiliary jack, the mode does not switch to the AUX mode.
Adjust the audio volume using the portable audio device, commander switch, or audio control switch.
Audio adjustments can also be made using the portable audio device's volume setting.
If the connection plug is pulled out from the auxiliary jack while in AUX mode, noise may occur

Error Indications (Type A)

If you see an error indication on the display, find the cause in the chart. If you cannot clear the error indication, take the vehicle to an Authorized Mazda Dealer. Indication C ...

How to use USB mode (Type B)

Type Playable data USB mode MP3/WMA/AAC/OGG file This unit does not support a USB 3.0 device. In addition, other devices may not be supported depending on the mo ...

Other materials:

Rear Lateral Link Removal/Installation
1. Remove in the order indicated in the table. 2. Install in the reverse order of removal. 3. Inspect the wheel alignment and adjust it if necessary.. 1 Rear stabilizer control link upper nut 2 Rear lateral link (See Rear Lateral Link ...

Pilot Bearing Inspection [A26 M R]
CAUTION: Secure the steering wheel using tape or a cable to prevent the steering shaft from rotating after disconnecting the steering shaft. If the steering wheel rotates after the steering shaft and the steering gear and linkage are disconnected, the internal parts of the clock spr ...

Ignition Coil/Ion Sensor Removal/Installation [Skyactiv G 2.0]
1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove the plug hole plate.. 4. Remove the plug hole plate bracket.. 5. Remove in the order indicated in the table. 6. Install in the reverse order of removal. 1 Connector ...