Mazda 3 Service Manual: HVAC SST

Airflow Mode Main Link Removal/Installation

1. Set the air intake mode to FRESH. 2. Set the air mix mode to MAX COLD. 3. Disconnect the negative battery cable.. 4. Remove the following parts: a. Front doors. b. Front scuff plate. c. ...

Heater Core Inspection

1. Inspect the heater core for damage, cracks, and water leakage. If there is any malfunction, replace the heater core. 2. Visually inspect the fins for bending. If there is any ...

Other materials:

Service Cautions
Injury/damage Prevention Precautions Depending on the vehicle, the cooling fan may operate suddenly even when the ignition is switched to off. Therefore, keep hands and tools away from the cooling fan even if the cooling fan is not operating to prevent injury to personnel or damage t ...

Transaxle Oil Inspection [G35 M R]
1. Park the vehicle on level ground. 2. Remove the aerodynamic under cover No.2.. 3. Remove the oil level plug and washer. 4. Verify that the oil is near the brim of the plug port. If the oil level is lower than the low level, add the specified amount and type of oil through the ...

Oil Control Valve (OCV) Removal/Installation [Skyactiv G 2.0]
WARNING: A hot engine can cause severe burns. Turn off the engine and wait until it is cool before servicing. 1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove the plug hole plate.. 4. Remove the ignition coil/ion sensors.. 5. Remove the cyli ...