Mazda 3 Owners Manual: Identification Numbers
Vehicle Identification Number
The vehicle identification number legally identifies your vehicle. The number is on a plate attached to the cowl panel located on the left corner of the dashboard. This plate can easily be seen through the windshield
Motor Vehicle Safety Standard Label (U.S.A. and Canada)
For vehicle identification number beginning with JM1
For vehicle identification number beginning with 3MZ *
*1 Check the vehicle identification number on the vehicle identification number plate. Refer to Vehicle Identification Number on .
Chassis Number
Open the cover shown in the figure to check the chassis number.
Vehicle Emission Control Information Label (U.S.A. and Canada)
Tire Pressure Label
For vehicle identification number beginning with JM1
For vehicle identification number beginning with 3MZ *1
*1 Check the vehicle identification number on the vehicle identification number plate. Refer to Vehicle Identification Number on .
Engine Number
Specifications
...
Specifications
Engine
Electrical System
*1 Q-85 is designed for i-ELOOP system. Only Q-85 should be used to ensure
correct operation of i-ELOOP
system. Consult an Authorized Mazda Dealer for details.
...
Other materials:
Front Crossmember Removal/Installation
CAUTION:
Performing the following procedures without first removing the ABS wheel-speed
sensor may possibly cause an open circuit in the wiring harness if it is pulled
by mistake. Before performing the following procedures, disconnect the ABS wheel-speed
sensor wiring harness connec ...
Maintaining the Finish
Washing
CAUTION
When the wiper lever is in the
position and the ignition is switched ON,
the wipers may move automatically in
the following cases:
If the windshield above the rain
sensor is touched or wiped with a
cloth.
If the windshield is struc ...
Air Filter Inspection [Mzr 2.0, Mzr 2.5]
Except for Mexico
Airflow inspection
1. Remove the air filter..
2. Blow from port A and verify that there is airflow from port B.
If there is no airflow, replace the air filter..
3. Blow from port B and verify that there is airflow from port A.
If there is no airflow, r ...
