On-Vehicle Inspection
1. Inspect the power supply circuit for the intermediate sensor.
a. Set the battery component (ex: battery, battery tray and PCM component) out of the way.
b. Disconnect the intermediate sensor connector.
c. Switch the ignition to ON (engine off).
d. Measure the voltage at intermediate sensor connector terminal A (harness-side).
If there is any malfunction, repair wiring harness between intermediate sensor and AT main relay.
B+
e. Switch the ignition to off.
f. Connect the intermediate sensor connector.
2. Inspect the GND circuit for the intermediate sensor.
a. Switch the ignition to off.
b. Measure the voltage at intermediate sensor connector terminal C (harness-side).
If there is any malfunction, repair wiring harness between intermediate sensor and GND.
Below 1.0 V
3. Inspect the signal circuit for the intermediate sensor.
a. Connect the oscilloscope to the following TCM connector terminals and set it as below.
(+) lead: TCM terminal AC
(-) lead: battery negative terminal
Oscilloscope setting: 1 V/DIV (Y), 200 μs/DIV (X), DC range
b. Start the engine.
c. Measure the wave form when the following conditions are met.
Gear position: 3GR
Vehicle speed: 30 km/h {19 mph}
If there is any malfunction, replace the intermediate sensor..
Vacuum Hose Removal/Installation [Mzr 2.0, Mzr 2.5]
1. Remove the battery and battery tray..
2. Remove the vacuum hose from the vacuum hose clip.
3. Insert a thin flathead screwdriver at the point indicated by the arrow in
the figure, push the ring down and disconnect the vacuum hose from the intake manifold.
4. Move the vacuum hose ...
Audio Amplifier Removal/Installation
1. Slide the passenger seat rearward.
2. Remove the cover.
3. Remove the bolt.
4. Detach the clips and set the vehicle wiring harness aside.
5. Slide the passenger seat forward.
6. Disconnect the negative battery cable..
7. Remove the caps.
8. Remove the nuts.
9. Disconnect t ...
General Procedures (Brake)
Wheel and Tire Installation
1. When installing the wheels and tires, tighten the wheel nuts in a criss-cross
pattern to the following tightening torque.
Tightening torque
88—118 N·m {9.0—12 Kgf·m, 65—87 ft·lbf}
Brake Lines Disconnection
1. If any brake line has been disconnec ...