Mazda 3 Service Manual: Joint Shaft Disassembly [Skyactiv G 2.0]
1. Disassemble in the order indicated in the table.
|
1 |
Snap ring |
|
2 |
Joint shaft component . |
|
3 |
Dust seal |
|
4 |
Bearing |
|
5 |
Dust cover |
|
6 |
Joint shaft |
Joint Shaft Component Disassembly Note
1. After removing the snap ring, remove the dust seal and the bearing from the joint shaft component using a press.
Joint Shaft Disassembly [Mzr 2.3 Disi Turbo]
1. Disassemble in the order indicated in the table.
1
Joint shaft component
.
2
Bearing
.
3
Dust seal (LH)
...
Joint Shaft Inspection
1. Verify that there is no torsion or cracks on the joint shaft.
If there is any malfunction, replace the joint shaft.
2. Turn the joint shaft by hand and verify that the bearing rotates ...
Other materials:
Transaxle Oil Inspection [G66 M R]
1. Park the vehicle on level ground.
2. Remove the aerodynamic under cover No.2..
3. Remove the oil level plug and washer.
4. Verify that the oil is near the brim of the plug port.
If the oil level is lower than the low level, add the specified amount and
type of oil through the ...
Pressure Sensor Removal/Installation [Two Step Deployment Control System]
1. Switch the ignition to off.
2. Disconnect the negative battery cable and wait for 1 min or more..
3. Remove the inner garnish..
4. Remove the front door trim..
5. Remove the bolts.
6. Remove the pressure sensor.
7. Disconnect the connector from the pressure sensor by pressing the ...
Making a Call
Phonebook Usage
Telephone calls can be made by saying
the contact name in the downloaded
phonebook or the name of a person whose
phone number has been registered in the
Bluetooth ® Hands-Free. Refer to Import
contact (Download Phonebook).
Press the talk button.
Wait for the beep sound.
...
