Mazda 3 Service Manual: Key Interlock System Inspection
Key Interlock System Inspection
1. Switch the ignition to ON.
2. Perform the following procedures to inspect the key interlock system.
-
If there is any malfunction, inspect the key interlock solenoid and NOT P position switch..
a. Verify that the ignition cannot be switched to off when the selector lever is not in the P position.
b. Verify that the ignition can be switched to off when the selector lever is in the P position.
Key Interlock Solenoid Inspection
1. Perform the following procedures.
a. Remove the battery cover..
b. Disconnect the negative battery cable..
c. Remove the column cover..
d. Disconnect the key interlock solenoid connector.
2. Measure the resistance between the key interlock solenoid terminals A and B.
-
If there is any malfunction, replace the steering lock..
-
Key interlock solenoid specification
-
Approx.36 ohms
NOT P Position Switch Inspection
1. Perform the following procedures.
a. Remove the battery cover..
b. Disconnect the negative battery cable..
c. Remove the console..
d. Disconnect the selector lever component connector.
2. Inspect the continuity between the selector lever component terminals G and K.
-
If there is any malfunction, replace the selector lever component..
|
Test condition |
Continuity |
|
P position |
No continuity |
|
Except P position |
Continuity |
Judder Upon Torque Converter Clutch (TCC) Operation [Fw6 A EL]
TROUBLESHOOTING ITEM
Judder upon torque converter clutch (TCC) operation
DESCRIPTION
Vehicle jolts when TCC is engaged.
...
M Position Switch Inspection [FS5 A EL]
1. Perform the following procedures.
a. Remove the battery cover..
b. Disconnect the negative battery cable.
c. Remove the console..
d. Disconnect the selector lever component connector.
...
Other materials:
Restraints SST [Two Step Deployment Control System]
49 H066 002
Deployment tool
49 D066 002
Adapter harness
49 L066 002
Adapter harness
49 G066 003
Adapter harness
49 N088 0A0
Fuel and Therm ...
Variable Tumble Solenoid Valve Inspection [Mzr 2.0, Mzr 2.5]
Airflow Inspection
1. Remove the battery cover..
2. Disconnect the negative battery cable..
3. Remove the variable tumble solenoid valve..
4. Inspect airflow between the ports under the following conditions.
If not as specified, replace the variable tumble solenoid valve..
...
Steering Shaft Inspection
1. Inspect the column bearing for excessive play and damage.
2. Verify that the measurement of the steering shaft indicated in the figure
is as specified.
If not within the specification replace the steering shaft component.
Steering shaft length
315—320 mm {12.41—12.59 ...
