Mazda 3 Service Manual: Keyless Antenna Removal/Installation

Mazda 3 Service Manual / Accessories / Electronics / Entertainment / Keyless Antenna Removal/Installation

Interior, Front

1. Disconnect the negative battery cable..

2. Remove the following parts:

a. Upper panel.

b. Shift knob (MTX).

c. Selector lever knob (ATX).

d. Shift panel.

e. Side wall.

f. Center panel.

g. Audio unit.

h. Rear heat duct (1).

3. Disconnect the connector.

4. Remove the nuts.

5. Remove the keyless antenna.

6. Install in the reverse order of removal.

Interior, Rear

1. Disconnect the negative battery cable..

2. Remove the rear seat cushion..

3. Disconnect the connector.

4. Remove the nuts.

5. Remove the keyless antenna.

6. Install in the reverse order of removal.

Exterior, Rear

1. Disconnect the negative battery cable..

2. Remove the rear combination light..

3. Remove the rear bumper..

4. Remove the nuts.

5. Disconnect the connector.

6. Remove the keyless antenna.

7. Install in the reverse order of removal.

Exterior, LF/RF

NOTE:

The keyless antenna (vehicle exterior, LF/RF) is built into the front outer handle..

Installation Of Radio System

The control modules and control unit have been designed with sufficient attention to radio wave disturbances from the outside. However, observe the following precautions when installing the radio ...

Rear Center Speaker Inspection

1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Rear seat cushion. b. Rear scuff plate. c. Tire house trim. d. C-pillar trim. e. Rear package trim. f. Rear c ...

Other materials:

How to use AUX mode (Type B)
Select the icon on the home screen to display the Entertainment screen. Select to switch to the AUX mode. The following icons are displayed in the lower part of the center display. Icon Function Displays the Entertainment menu. Use to switch to a diffe ...

Theft Deterrent System Clearing Freeze Frame Data
1. Connect the M-MDS (IDS) to the DLC–2. 2. After the vehicle is identified, select the following items from the initialization screen of the IDS. Select “Body”. Select "Burglar Service Functions". 3. Then, select the following item from the screen menu. ...

PID/Data Monitor Inspection [Blind Spot Monitoring (Bsm)]
1. Connect the M-MDS (IDS) to the DLC-2. 2. After the vehicle is identified, select the following items from the initialization screen of the IDS. a. Select “DataLogger”. b. Select “Modules”. c. Select “BSML” or “BSMR”. 3. Select the applicable PID from the PID table. 4. Verify the ...