Mazda 3 manuals

Mazda 3 Service Manual: Liftgate Latch And Lock Actuator Removal/Installation

Mazda 3 Service Manual / Body / Doors/Lids & Hood/Trunk / Liftgate Latch And Lock Actuator Removal/Installation

1. Disconnect the negative battery cable..

2. Remove the following parts:

a. Liftgate upper trim.

b. Liftgate side trim.

c. Liftgate lower trim.

3. Disconnect the connector.


4. Remove the bolts.


5. Remove the liftgate latch and lock actuator.

6. Install in the reverse order of removal.

Liftgate Latch And Lock Actuator Inspection
1. The following actuator and switch are integrated with the liftgate latch and lock actuator. Inspect the liftgate latch and lock actuator according to each inspection procedure for the following ...

Liftgate Latch Switch Inspection
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Liftgate upper trim. b. Liftgate side trim. c. Liftgate lower trim. d. Liftgate latch and lock actuator. 3. Pre ...

Other materials:

Installing Child-Restraint Systems
Accident statistics reveal that a child is safer in the rear seat. The front passenger's seat is clearly the worst choice for any child under 12, and with rear-facing childrestraint systems it is clearly unsafe due to air bags. NOTE Even if your vehicle is equipped with front passenger seat w ...

Auxiliary Jack/Usb Port
NOTE: “iPod” is a registered trademark of Apple Inc. in the United States and other countries. Purpose, Function The Auxiliary jack/USB port outputs the audio signals of commercially-available portable audio, a USB device, or an iPod connected to the Auxiliary jack/USB ...

On Board Diagnostic System Simulation Inspection [FS5 A EL]
1. Connect the M-MDS(IDS) to the DLC-2. 2. After the vehicle is identified, select the following items from the initialization screen of the IDS. a. Select "DataLogger". b. Select "Modules". c. Select "TCM". 3. Select the simulation items from the PID ta ...

© 2016-2024 Copyright www.mazda3tech.com