Mazda 3 Service Manual: Lighting System Personalization Features Setting Procedure
Auto Light System
1. Connect the M-MDS (IDS) to the DLC-2.
2. After the vehicle is identified, select the following items from the initial screen of the IDS.
-
Select the “Module Programming”
-
Select the “Programmable Parameters”.
-
Select menu in the Exterior Lighting.
3. Select an item name, and then select option.
|
M-MDS display |
Function |
Initial setting |
Setting content |
Control unit |
|
Autolamp On Setting |
The auto light system sensitivity can be adjusted. |
Standard (Except Japan) |
Extra Low (Except Japan) / Low (Except Japan) / Standard (Except Japan) / High (Except Japan) / Extra High (Except Japan) |
BCM |
NOTE:
-
Other than the above conditions, an “Japan Only” command is also displayed, however, do not select the command because it is for use other than in Japan.
-
If the mode is set to “Extra High (Except Japan)” and “High (Except Japan)”, the illumination level for illuminating the TNS and headlight increases. Therefore, the TNS and headlights illuminate when the ambient light is brighter than when the level is set to “Standard (Except Japan)”. In addition, if the mode is set to “Low (Except Japan)” and “Extra Low (Except Japan)”, the illumination level for illuminating the TNS and headlights decreases. Therefore, the TNS and headlights illuminate when the ambient light is lower than when the level is set to “Standard (Except Japan)”.
Interior Light Control System / Turn Light System
-
The interior light control system and turn light system is controlled by the BCM. For the interior light control system setting, refer to the personalization function setting procedure..
Indirect Illumination Removal/Installation
Power Window Switch (With power window switch indirect illumination)
1. Disconnect the negative battery cable..
2. Remove the assist handle cover..
3. Remove in the order indicated in the table. ...
Rear Turn Light Bulb Removal/Installation
4SD
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Trunk mat.
b. Trunk board.
c. Trunk end trim.
3. Partially peel back the trunk side trim..
4. Remove in th ...
Other materials:
Operating Tips
Operate the climate control system with
the engine running.
To prevent the battery from being
discharged, do not leave the fan control
dial on for a long period of time with the
ignition switched ON when the engine is
not running.
Clear all obstructions such as leaves,
snow and ic ...
Registering Your Vehicle in A Foreign
Country (Except United States and
Canada)
Registering your vehicle in a foreign country may be problematic depending on
whether it
meets the specific emission and safety standards of the country in which the
vehicle will be
driven. Consequently, your vehicle may require modifications at personal expense
in order
to meet the regulat ...
Air Bleeding
CAUTION:
If the strainer is removed, impurities may penetrate the power steering system
and damage it. To prevent this, always bleed air with the strainer installed.
Do not maintain the steering wheel fully turned for 5 s or more. The oil
temperature could rise and damage ...
