Mazda 3 Service Manual: M Position Switch Inspection [Fw6 A EL]

Mazda 3 Service Manual / Drivetrain / Transmission/Transaxle / Automatic / M Position Switch Inspection [Fw6 A EL]

Continuity Inspection

NOTE:

The M position switch is built into the selector lever component.

1. Remove the battery cover..

2. Disconnect the negative battery cable..

3. Remove the console..

4. Disconnect the selector lever component connector.

5. Verify that the continuity between selector lever component terminals A and H.

If not as verified, replace the selector lever component..

M position switch specification


Test condition	Continuity
Selector lever is in the M position.	Continuity
Selector lever is not in the M position.	No continuity

M Position Switch Inspection [FS5 A EL]

1. Perform the following procedures. a. Remove the battery cover.. b. Disconnect the negative battery cable. c. Remove the console.. d. Disconnect the selector lever component connector. ...

Neutral Switch Removal/Installation [A26 M R]

1. Disconnect the negative battery cable. 2. Disconnect the neutral switch connector. 3. Remove the aerodynamic under cover No.2.. 4. Remove the neutral switch with the gasket. 5. Install ...

Other materials:

Reporting Safety Defects (U.S.A.)
If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHTSA) in addition to notifying Mazda Motor Corporation (Your Mazda Importer/Distributor). If NHTSA re ...

Air Intake Actuator Inspection [Manual Air Conditioner]
1. Connect battery positive voltage to air intake actuator terminal B (or C), connect terminal C (or B) to ground, and then verify that the air intake actuator operates as shown in the table. If the operation condition is not normal, replace the air intake actuator. ...

Vehicle Speed Sensor (VSS) Inspection [FS5 A EL]
On-Vehicle Inspection 1. Inspect the power supply circuit for the VSS. a. Remove the insulator from the transaxle. b. Disconnect the VSS connector. c. Switch the ignition to ON (engine off). d. Measure the voltage at VSS connector terminal A (harness-side). If there is a ...