Mazda 3 Service Manual: Manifold Absolute Pressure (Map) Sensor/Boost Air Temperature Sensor Removal/Installation [Mzr 2.3 Disi Turbo]
NOTE:
-
Because the boost air temperature sensor is integrated in the MAP sensor, replacing the boost air temperature sensor includes replacement of the MAP sensor/boost air temperature sensor.
1. Remove the battery cover..
2. Disconnect the negative battery cable..
3. Remove the dipstick pipe..
4. Disconnect the MAP sensor/boost air temperature sensor connector.
5. Remove the MAP sensor/boost air temperature sensor.
6. Install in the reverse order of removal.
Input/Turbine Speed Sensor Removal/Installation [FS5 A EL]
CAUTION:
Always use a new bolt. If the removed input/turbine speed sensor installation
bolt is reused, it may cause oil leakage.
A sealant coating is applied to the input/turbine s ...
Passenger Compartment Temperature Sensor Inspection [Full Auto Air Conditioner]
1. Measure the temperature around the passenger compartment temperature sensor
and measure the resistance between passenger compartment temperature sensor terminals
B and D.
If the cha ...
Other materials:
Child Restraint Seat Anchor Removal/Installation
4SD
1. Remove the cover.
2. Remove the bolt and child-restraint seat anchor.
3. Install in the reverse order of removal.
5HB
1. Remove the trunk end trim..
2. Remove the bolt and child-restraint seat anchor.
3. Install in the reverse order of removal. ...
Fuse Panel Description
Fuse block (Engine compartment)
*1 With xenon fusion headlights
*2 With halogen headlights
Fuse block (Left side)
...
Antenna Feeder No.1 Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Front scuff plate.
b. Front side trim.
c. Upper panel.
d. Shift lever knob (MTX).
e. Selector lever knob (ATX).
f. Shift panel.
g. Side wall.
h. Console.
i. Shift lever component (MTX).
j. Selector lev ...
