1. Park the vehicle on level ground.
2. Remove the aerodynamic under cover No.2..
3. Remove the drain plug and gasket, and drain the manual transaxle oil.
4. Install a new gasket and the drain plug.
39—59 N·m {4.0—6.0 kgf·m, 29—43 ft·lbf}
5. Remove the oil level plug and gasket.
6. Add the specified manual transaxle oil through the oil level plug port.
API service GL-4
SAE 75W-80
7. Install a new gasket and the oil level plug.
39—59 N·m {4.0—6.0 kgf·m, 29—43 ft·lbf}
8. Install the aerodynamic under cover No.2..
Rear Coil Spring Removal/Installation
1. Disconnect the auto leveling sensor lower side. (Vehicles with AFS).
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
4. Inspect the wheel alignment and adjust it if necessary..
1
Rear stabilizer control link upper nut
...
How to Arm the System
Close the windows and the moonroof *
securely.
Switch the ignition OFF.
Make sure the hood, the doors, and the
liftgate/trunk lid are closed.
Press the lock button on the transmitter
or lock the driver's door from the
outside with the auxiliary key.
The hazard warning lights will ...
Quarter Window Glass Installation
WARNING:
Using a razor with bare hands can cause injury. Always wear gloves when using
a razor.
CAUTION:
If a door is opened or closed when all the window glass is closed, the resulting
change in air pressure could cause the sealant to crack preventing the proper
insta ...