Mazda 3 manuals

Mazda 3 Service Manual: Manual Transaxle Shift Mechanism Removal/Installation [A26 M R]

Mazda 3 Service Manual / Drivetrain / Transmission/Transaxle / Manual transmission / Manual Transaxle Shift Mechanism Removal/Installation [A26 M R]

1. Remove the battery cover..

2. Disconnect the negative battery cable.

3. Remove the battery and battery tray..

4. Remove the air cleaner and air inlet hose..

5. Remove the aerodynamic under cover NO.2..

6. Remove the tunnel member (rear)..

7. Remove the upper panel..

8. Remove the shift lever knob.


9. Remove the shift panel.

10. Remove the side wall..

11. Remove the console..

12. Detach the clip as shown in the figure.


13. Disconnect the drain hose connected to A/C unit..


14. Remove the cap and fastener securing the insulator (front) and set the insulator (front) aside.


15. Remove in the order indicated in the table.

16. Install in the reverse order of removal.

17. After installation, verify that the shift lever can be shifted smoothly into each position.



1

Clip

2

Grommet

3

Main shift cable

(See Main Shift Cable and Main Select Cable Removal Note.)

4

Main select cable

(See Main Shift Cable and Main Select Cable Removal Note.)

5

Shift lever component


Main Shift Cable and Main Select Cable Removal Note

1. Remove the both shift cable end and select cable end using a fastener remover.


Manual Transaxle Removal/Installation [G66 M R]
CAUTION: Secure the steering wheel using tape or a cable to prevent the steering shaft from rotating after disconnecting the steering shaft. If the steering wheel rotates after the steer ...

Manual Transaxle Shift Mechanism Removal/Installation [C66 M R]
1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove the shift lever. a. Remove the upper panel.. b. Remove the shift lever knob. c. Remove the shift panel. ...

Other materials:

Front Combination Light Bracket Replacement
NOTE: Verify that the front combination light is not damaged before using the repair bracket for installation when the original brackets are damaged. If the front combination light component is damaged, replace the light as a single unit. 1. Cut off the front combination light br ...

No.7 Bsm Indicator Light Does Not Flash While Under Bsm Indicator Light Flashing Conditions (With Combination Switch Operation (Turn Signal Switch)) [Blind Spot Monitoring (Bsm)]
7 BSM indicator light does not flash while under BSM indicator light-flashing conditions (with combination switch operation (turn signal switch)) Description The BSM indicator light does not flash or illuminate continuously, ...

Battery Replacement
If the buttons on the transmitter are inoperable and the operation indicator light does not flash, the battery may be dead. Replace with a new battery before the transmitter becomes unusable. CAUTION Make sure the battery is installed correctly. Battery leakage could occur if ...

© 2016-2024 Copyright www.mazda3tech.com