Mazda 3 Service Manual: Manual transmission Clutch

Neutral Switch Removal/Installation [G66 M R]

1. Remove the battery cover.. 2. Disconnect the negative battery cable. 3. Remove the battery component. (ex: battery, battery tray and PCM component). 4. Remove the aerodynamic under cover No. ...

Clutch Cover Inspection [C66 M R]

1. Remove the clutch cover.. 2. Perform the following procedures to inspect the clutch cover. If it exceeds the maximum specification, replace the clutch cover.. a. Measure the wear of ...

Other materials:

Child-Restraint System Installation
Child-Restraint System Types In this owner's manual, explanation of child-restraint systems is provided for the following three types of popular childrestraint systems: infant seat, child seat, booster seat. NOTE Installation position is determined by the type of child-restraint system. ...

Trunk Lid Opener Lever Removal/Installation
1. Remove the front scuff plate (LH).. 2. Remove the front side trim (LH).. 3. Remove the fuel-filler lid opener bezel.. 4. Partially peel back the floor covering. 5. Remove the bolts. 6. Disconnect the cable and trunk lid opener lever. 7. Install in the reverse order of removal. ...

Automatic Transaxle Fluid (ATF) Replacement [Fw6 A EL]
WARNING: Do not perform the servicing while the ATF is hot. Otherwise, it could cause severe burns or serious injury. 1. Remove aerodynamic undercover No.2.. 2. Remove the dipstick securing bolt. 3. Remove the dipstick. 4. Remove the drain plug and washer, and drain the AT ...