Mazda 3 Service Manual: Master Cylinder Removal/Installation [Mzr 2.3 Disi Turbo]
1. Remove the battery and battery tray..
2. Pinch open the clamps using pliers and disconnect the vacuum hoses from the insulator bracket as shown in the figure.
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
|
1 |
Nut |
|
2 |
Insulator |
|
3 |
Brake fluid level sensor connector |
|
4 |
Reserve hose (See Reserve Hose Removal Note.) (See Reserve Hose Installation Note.) |
|
5 |
Brake pipe |
|
6 |
Nut |
|
7 |
Insulator bracket (See Insulator Bracket, Master Cylinder Removal Note.) (See Master Cylinder, Insulator Bracket Installation Note.) |
|
8 |
Master cylinder (See Insulator Bracket, Master Cylinder Removal Note.) (See Master Cylinder, Insulator Bracket Installation Note.) |
|
9 |
Cap |
|
10 |
Reserve tank |
|
11 |
Cylinder component |
Reserve Hose Removal Note
1. Remove the reserve hose from the reserve tank while pressing the point indicated by the arrow in the figure.
Insulator Bracket, Master Cylinder Removal Note
1. Remove the insulator bracket and master cylinder from the power brake unit as a single unit.
2. Remove the insulator bracket from the master cylinder.
Master Cylinder, Insulator Bracket Installation Note
1. Temporarily install the insulator bracket to the master cylinder.
2. Install the insulator bracket and master cylinder to the power brake unit as a single unit.
Reserve Hose Installation Note
1. Insert the reserve hose to the reserve tank until a click is heard.
2. Verify that the reserve hose is firmly installed by pulling it, and push it into the reserve tank again.
Master Cylinder Removal/Installation [Mzr 2.0, Skyactiv G 2.0, Mzr 2.5]
1. Remove the battery and battery tray..
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
1
Brake fluid level sensor connect ...
Power Brake Unit Inspection
NOTE:
The following inspection methods are simple inspection methods to judge the
function of the power brake unit.
If there is any malfunction in the power brake unit, replace the ...
Other materials:
Adaptive Front Lighting System
(AFS)
The adaptive front lighting system (AFS)
automatically adjusts the headlight beams
to the left or right in conjunction with the
operation of the steering wheel after the
headlights have been turned on.
AFS OFF Indicator Light
When illuminated
This indicator light illuminates briefly
when ...
Sunlight/Temperature Sensor
The climate control system measures
inside and outside temperatures, and
sunlight. It then sets temperatures inside
the passenger compartment accordingly.
CAUTION
Do not obstruct either sensor,
otherwise the climate control system
will not operate properly.
...
Fuel-Filler Lid and Cap
WARNING
When removing the fuel-fi ller cap,
loosen the cap slightly and wait for any
hissing to stop, then remove it:
Fuel spray is dangerous. Fuel can
burn skin and eyes and cause illness
if ingested. Fuel spray is released
when there is pressure in the fuel tank
and ...
