Mazda 3 manuals

Mazda 3 Service Manual: Oil Cooler Removal/Installation [FS5 A EL]

Mazda 3 Service Manual / Engine / Lubrication / Oil Cooler Removal/Installation [FS5 A EL]

1. Remove the battery cover..

2. Disconnect the negative battery cable.

3. Remove the air cleaner component..

4. Remove the aerodynamic under cover NO.2..

5. Drain the ATF..

6. Drain the engine coolant..

7. Remove in the order indicated in the table.



1

Water hose (connected to the outlet)

2

Water hose (connected to the thermostat)

3

Oil hose

(See Oil Hose Installation Note.)

4

Hose clamp

(See Oil Hose Installation Note.)

5

Connector bolt

6

Packing

7

Oil cooler


8. Install in the reverse order of removal.

9. Add the engine coolant..

10. Add the ATF..

11. Perform the “Mechanical System Test”..

Oil Hose Installation Note

1. Install the oil hose.

2. Install the hose clamp within the marked area of the oil hose.


NOTE:

3. Verify that the hose clamp does not interfere with any other components.

Oil Cooler Flushing [FS5 A EL]
NOTE: If the automatic transaxle is replaced, flush and inspect the oil cooler. When replacing the automatic transaxle, inspect the oil cooler together with flushing it using the fo ...

Oil Cooler Removal/Installation [Fw6 A EL]
1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove the aerodynamic under cover NO.2.. 4. Drain the ATF.. 5. Drain the engine coolant.. 6. Remove in the order ...

Other materials:

Operating Tips for MP3
MP3 stands for MPEG Audio Layer 3, which is standardized voice compression established by the ISO *1 working group (MPEG). Use of MP3 allows for audio data to be compressed to approximately a tenth of the source data size. This unit plays files with the extension (.mp3) as MP3 files. ...

Control Valve Body Removal/Installation [FS5 A EL]
Primary Control Valve Body On-Vehicle Removal WARNING: A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool. Using compressed air can cause dirt and other particles to fly out, causing injury to the eyes. Wear protective eyeglasses w ...

Clutch Master Cylinder Removal/Installation [C66 M R]
CAUTION: Secure the steering wheel using tape or a cable to prevent the steering shaft from rotating after disconnecting the steering shaft. If the steering wheel rotates after the steering shaft and the steering gear and linkage are disconnected, the internal parts of the clock spr ...

© 2016-2024 Copyright www.mazda3tech.com