Mazda 3 manuals

Mazda 3 Service Manual: Oil Cooler Removal/Installation [Fw6 A EL]

Mazda 3 Service Manual / Engine / Lubrication / Oil Cooler Removal/Installation [Fw6 A EL]

1. Remove the battery cover..

2. Disconnect the negative battery cable..

3. Remove the aerodynamic under cover NO.2..

4. Drain the ATF..

5. Drain the engine coolant..

6. Remove in the order indicated in the table.



1

Water hose (connected to the water pipe)

2

Water hose (connected to the outlet)

3

Water-cooled oil cooler

4

O-rings


7. Install in the reverse order of removal.

8. Add the engine coolant..

9. Add the ATF..

10. Perform the “Mechanical System Test”..

Water Hose Installation Note

1. Install the water hose to the oil cooler as shown in the figure with the hose clamp expanded.

NOTE:


2. Install the hose clamp to the position shown in the figure.


3. Verify that the hose clamp does not interfere with any other components.

Oil Cooler Removal/Installation [FS5 A EL]
1. Remove the battery cover.. 2. Disconnect the negative battery cable. 3. Remove the air cleaner component.. 4. Remove the aerodynamic under cover NO.2.. 5. Drain the ATF.. 6. Drain the eng ...

Oil Cooler Removal/Installation [Mzr 2.0, Mzr 2.5]
WARNING: Hot engines and engine oil can cause severe burns. Turn off the engine and wait until it and the engine oil have cooled. A vehicle that is lifted but not securely supported ...

Other materials:

Judder Upon Torque Converter Clutch (TCC) Operation [Fw6 A EL]
TROUBLESHOOTING ITEM Judder upon torque converter clutch (TCC) operation DESCRIPTION Vehicle jolts when TCC is engaged. POSSIBLE CAUSE Signal malfunction APP ...

Pressure Sensor Removal/Installation [Two Step Deployment Control System]
1. Switch the ignition to off. 2. Disconnect the negative battery cable and wait for 1 min or more.. 3. Remove the inner garnish.. 4. Remove the front door trim.. 5. Remove the bolts. 6. Remove the pressure sensor. 7. Disconnect the connector from the pressure sensor by pressing the ...

Operating Tips for MP3
MP3 stands for MPEG Audio Layer 3, which is standardized voice compression established by the ISO *1 working group (MPEG). Use of MP3 allows for audio data to be compressed to approximately a tenth of the source data size. This unit plays files with the extension (.mp3) as MP3 files. ...

© 2016-2024 Copyright www.mazda3tech.com