Mazda 3 Service Manual: Oil Pressure Switch Inspection [FS5 A EL]
CAUTION:
-
Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the connector when disconnecting it.
On-Vehicle Inspection
1. Perform the following procedures.
a. Remove the aerodynamic under cover NO.2..
b. Disconnect the oil pressure switch connector.
2. Start the engine.
3. Inspect the continuity between the oil pressure switch terminal A and body GND.
-
If there is any malfunction, replace the oil pressure switch..
|
Test Condition |
Continuity |
|
In P position |
No continuity |
|
In R position |
No continuity |
|
In N position |
No continuity |
|
In D position |
Continuity |
Off-Vehicle Inspection
1. Apply air pressure at 400—440 kPa {4.08—4.48 kgf/cm2,58.1—63.8 psi} as shown in the figure.
2. Inspect continuity between the oil pressure switch terminal A and screw part.
-
If there is any malfunction, replace the oil pressure switch..
|
Test Condition |
Continuity |
|
Applying air pressure |
Continuity |
|
Applying no air pressure |
No continuity |
Oil Pressure Switch Inspection
MZR 2.0, MZR 2.5, MZR 2.3 DISI Turbo
WARNING:
A hot engine can cause severe burns. Turn off the engine and wait until it
is cool before removing the exhaust system.
1. Disconnect the ...
Oil Pressure Switch Removal
MZR 2.0, MZR 2.5, MZR 2.3 DISI Turbo
WARNING:
A hot engine can cause severe burns. Turn off the engine and wait until it
is cool before removing the exhaust system.
1. Disconnect the ...
Other materials:
Transaxle Oil Inspection [A26 M R]
1. Park the vehicle on level ground.
2. Remove the aerodynamic under cover No.2..
3. Remove the oil level plug and gasket.
4. Verify that the oil is near the brim of the plug port.
If the oil level is lower than the low level, add the specified amount and
type of oil through the ...
Control System Personalization Features Setting Procedure
1. Connect the M-MDS to the DLC-2.
2. After the vehicle is identified, select the following items from the initial
screen of the M-MDS.
When using the IDS (laptop PC)
Select the “Module Programming”.
Select the “Programmable Parameters”.
3. Select ...
Intermediate Sensor Removal/Installation [FS5 A EL]
CAUTION:
If foreign materials are stuck to the sensor, disturbance by magnetic flux
can cause sensor output to be abnormal and thereby negatively affect control.
Make sure that foreign materials such as iron filings are not stuck to the sensor
during installation.
1. Perform t ...
