1. Remove the aerodynamic under cover No.2 and the splash shield as a single unit..
2. Remove the oil seal.
a. Drain the ATF..
b. Disconnect the drive shaft (LH) from the transaxle..
c. Disconnect the drive shaft (RH) from the joint shaft..
d. Remove the joint shaft..
CAUTION:
The oil seal is easily damaged by the sharp edges of the drive shaft splines. Do not let the splines contact the oil seal.
e. Remove the oil seal using a flathead screwdriver.
3. Using the SSTs
and a hammer, tap a new oil seal in evenly until the SST
(49 U027 003
) contacts the transaxle case.
4. Coat the lip of the oil seal with ATF.
5. Install the joint shaft..
6. Install the drive shaft (RH) to the joint shaft..
7. Install the drive shaft (LH) to the transaxle..
8. Add the ATF..
9. Install the aerodynamic under cover No.2 and the splash shield as a single unit..
10. Perform the “Mechanical System Test”..
Rear Lateral Link Removal/Installation
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. Inspect the wheel alignment and adjust it if necessary..
1
Rear stabilizer control link upper nut
2
Rear lateral link
(See Rear Lateral Link ...
Air Intake Actuator Removal/Installation [Full Auto Air Conditioner]
1. Set the air intake mode to FRESH.
2. Disconnect the negative battery cable..
3. Remove the following parts:
a. Front scuff plate (Passenger-side).
b. Front side trim (Passenger-side).
c. Dashboard under cover.
d. Glove compartment.
e. Lower panel (Passenger-side).
f. Shower duct ( ...
Brake Pedal Removal/Installation
CAUTION:
The clearance between the brake switch and the brake pedal is automatically
adjusted to the correct amount when the brake switch is inserted into the installation
hole on the brake pedal and rotated to fix in place. If the brake switch is
not properly installed, the clearan ...