Normal opening/closing
To open the window to the desired position, lightly hold down the switch.
To close the window to the desired position, lightly pull up the switch.
Auto-opening/closing
To fully open the window automatically, press the switch completely down, then release. The window will fully open automatically.
To fully close the window automatically, pull the switch completely up, then release. The window will fully close automatically.
To stop the window partway, pull or press the switch in the opposite direction and then release it.
Power window system initialization procedure
If the battery was disconnected during vehicle maintenance, or for other reasons (such as a switch continues to be operated after the window is fully open/closed), the window will not fully open and close automatically.
The power window auto function will only resume on a power window that has been reset.
Jam-safe window
If a person's hands, head or an object blocks the window during the auto-closing operation, the window will stop and open halfway.
WARNING
Make sure nothing blocks the window
just before it reaches the fully closed
position or while holding up the power
window switch:
Blocking the power window just before
it reaches the fully closed position or
while holding up the power window
switch is dangerous. In this case, the jam-safe function cannot prevent the window from closing all the way. If fi ngers are caught, serious injuries could occur. |
NOTE
Engine-off power window operation
The power window can be operated for about 40 seconds after the ignition is switched from ON to off with all doors closed. If any door is opened, the power window will stop operating.
NOTE For engine-off operation of the power window, the switch must be held up firmly throughout window closure because the auto-closing function will be inoperable.
Front Seat Back Trim Removal/Installation
WARNING:
Handling a front seat (with built-in side air bag) improperly can accidentally
operate (deploy) the air bag, which may seriously injure you. Read the service
warnings before handling a front seat (with built-in side air bag)..
CAUTION:
After removing a front seat ...
Wheel Hub Component Inspection
Wheel Bearing Excessive Play Inspection
1. Remove the brake caliper component and disc plate..
2. Install the magnetic base and dial gauge as shown in the figure and measure
the wheel bearing axial excessive play.
If it exceeds the maximum specification, replace the wheel hub compon ...
Airflow Mode Actuator Inspection [Full Auto Air Conditioner]
CAUTION:
If the lever position exceeds the operation range shown in the figure, the
circuit in the actuator could be damaged. Always perform an actuator operation
inspection with the lever movement within the range shown in the figure.
1. Connect battery positive voltage to airfl ...