Mazda 3 Service Manual: Parameter Setting Procedure When Tire Size Is Changed

Mazda 3 Service Manual / Suspension / Wheels, Tires / Parameter Setting Procedure When Tire Size Is Changed

CAUTION:

If the wheel and tire sizes are changed, a discrepancy with the speedometer needle whereby it exceeds the allowable range could result in a malfunction. If the wheel and tire sizes are changed, perform the following procedure to change the tire size parameter setting.
The same parameters should be set in “Tire dimension”, “Tire Circumference”, and “Tire Size”.

1. Connect the M-MDS to DLC-2.

2. After the vehicle is identified, select the following item from the initialization screen of the M-MDS.

Select “Module Programming”.

3. Select the items from the screen menu.

Select “Programmable Parameters”.
Select “Tire Size”.

4. Select an item name, and then select the option.

Select “Tire Size”.

Tire dimension (195/70R15, 205/50R17, 195/65R15, 205/55R16, 225/40R18)
Tire Circumference (195/70R15, 205/50R17, 195/65R15, 205/55R16, 225/40R18)

5. Select the items from the screen menu.

Select “Programmable Parameters”.
Select “Tire Size/Axle Ratio”.

6. Select an item name, and then select the option.

Select “Tire Size/Axle Ratio”.

Tire Size (195/70R15, 225/40R18, 195/65R15, 205/50R17, 205/55R16)

Malfunctioning Wheel Unit Identification

NOTE: The tire pressure monitoring system (TPMS) does not identify the location of the malfunctioning wheel unit on the vehicle (RF, LF, LR, RR). The TPMS identifies each wheel unit as N ...

Tire House Trim Removal/Installation

4SD 1. Remove the rear seat cushion.. 2. Remove the rear scuff plate.. 3. Partially peel back the seaming welt. 4. Remove the fastener. 5. Pull the tire house trim in the direction of arrow s ...

Other materials:

Oil Seal (Differential) Replacement [C66 M R]
1. Remove the aerodynamic under cover No.2 and the splash shield as a single unit.. 2. Drain the manual transaxle oil.. 3. Disconnect the drive shaft (LH) from the MTX.. 4. Disconnect the drive shaft (RH) from the joint shaft.. 5. Remove the joint shaft.. 6. Remove the oil seal (LH). ...

Vacuum Hose Removal/Installation [Skyactiv G 2.0]
1. Remove the plug hole plate.. 2. Remove the battery and battery tray.. 3. Remove the vacuum hose from the vacuum hose clip. 4. Pinch open the clamp using pliers and disconnect the vacuum hose from the vacuum pump. 5. Move the vacuum hose as shown in the figure. 6. Disconnect th ...

Auto Lock/Unlock Function
WARNING Do not pull the inner handle on a front door: Pulling the inner handle on a front door while the vehicle is moving is dangerous. Passengers can fall out of the vehicle if the door opens accidentally , which could result in death or serious injury. When ...