Mazda 3 Service Manual: Parking Brake

Rear Brake (Disc) Removal/Installation

CAUTION: If the brake hose is installed to the caliper on the vehicle, the tool cannot be installed correctly resulting in brake fluid leakage due to improper installation. Therefore, re ...

Parking Brake Cable Removal/Installation

1. Remove the following parts: a. Upper panel. b. Shift knob (MTX). c. Selector lever knob (ATX). d. Shift panel. e. Side wall. f. Console. 2. Remove the under cover.. 3. Remove the tu ...

Other materials:

Wheel Unit Removal/Installation
1. Remove in the order indicated in the table. 2. Install in the reverse order of removal. 3. Install the valve core and valve cap, put air into the tire. CAUTION: A TPMS wheel unit has an exclusive valve cap and valve core. If a valve core other than the exclusive one is installed, ...

Joint Shaft Removal/Installation [Skyactiv G 2.0]
CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor connector (axle side) and ...

Center Roof Antenna Removal/Installation
4SD 1. Disconnect the negative battery cable.. 2. Remove the rain sensor cover. (Vehicles with auto light/wiper system). 3. Disconnect the rain sensor connector. (Vehicles with auto light/wiper system) 4. Partially peel back the seaming welts. 5. Remove the following parts: a. Sunroof se ...