Mazda 3 Service Manual: Parking Brake Cable Removal/Installation
1. Remove the following parts:
a. Upper panel.
b. Shift knob (MTX).
c. Selector lever knob (ATX).
d. Shift panel.
e. Side wall.
f. Console.
2. Remove the under cover..
3. Remove the tunnel member (rear). (MZR 2.0, MZR 2.5, MZR 2.3 DISI Turbo).
4. Remove the brace bar. (SKYACTIV-G 2.0).
5. Remove the TWC. (MZR 2.0, MZR 2.5, SKYACTIV-G 2.0).
6. Remove the presilencer. (MZR 2.3 DISI Turbo).
7. Remove the insulator (middle No.1) and the insulator (middle No.2)..
8. Remove in the order indicated in the table.
9. Install in the reverse order of removal.
10. After installation, inspect the parking brake stroke and adjust if necessary..
|
1 |
Parking brake switch connector |
|
2 |
Adjusting nut |
|
3 |
Bolt |
|
4 |
Parking brake lever |
|
5 |
Nut |
|
6 |
Parking brake cable (See Parking Brake Cable Installation Note.) |
Parking Brake Cable Installation Note
1. Pass the parking brake cable inside the rear ABS wheel-speed sensor wiring harness as shown in the figure.
2. Install the rear parking brake cable.
3. Verify that the end of the parking brake cable outer end is out of the caliper as shown in the figure.
Parking Brake
...
Parking Brake Lever Adjustment
1. Pump the brake pedal a few times.
2. Remove the upper panel..
3. Turn the adjusting nut and adjust the parking brake lever.
4. After adjustment, pull the parking brake lever one notch and ...
Other materials:
Oil Filter Replacement [Mzr 2.0, Mzr 2.5]
WARNING:
Hot engines and engine oil can cause severe burns. Turn off the engine and
wait until it and the engine oil have cooled.
A vehicle that is lifted but not securely supported on safety stands is dangerous.
It can slip or fall, causing death or serious injury. Never work ...
Crankshaft Position (CKP) Sensor Inspection [Mzr 2.0, Mzr 2.5]
Visual Inspection
CAUTION:
When foreign material such as an iron chip is on the CKP sensor, it can cause
abnormal output from the sensor because of flux turbulence and adversely affect
the engine control. Be sure there is no foreign material on the CKP sensor when
replacing.
...
Base Removal
1. Remove the rearview mirror..
2. Wind each end of a wire around a bar.
WARNING:
Using the piano wire with bare hands can cause injury. Always wear gloves
when using the piano wire.
NOTE:
Use a long sawing action to spread the work over the whole length of the
pi ...
