CAUTION:
Secure the steering wheel using tape or a cable to prevent the steering shaft from rotating after disconnecting the steering shaft. If the steering wheel rotates after the steering shaft and the steering gear and linkage are disconnected, the internal parts of the clock spring could be damaged.
NOTE:
Perform the pilot bearing inspection with the crankshaft or flywheel installed.
1. Perform the following procedures.
a. Remove the battery cover..
b. Disconnect the negative battery cable..
c. Remove the PCM cover No.1..
d. Disconnect the PCM connector..
e. Remove the battery tray and PCM component.
f. Remove the air cleaner component.
g. Remove the charge air cooler cover.
h. Remove the charge air cooler.
i. Remove the fuel pump resistor.
j. Remove the front tires.
k. Remove the splash shield.
l. Remove the aerodynamic under cover No.2.
m. Remove the WU-TWC bracket.
n. Remove the starter.
o. Remove the front auto leveling sensor.
p. Drain the transaxle oil into a suitable container..
q. Remove the manual transaxle..
r. Remove the clutch cover..
s. Remove the clutch disk..
2. Inspect the rotation condition of the pilot bearing for damage or wear.
If there is any malfunction, replace the pilot bearing..
Starter Interlock Switch Inspection [Mzr 2.3 Disi Turbo]
CAUTION:
Do not reuse the starter interlock switch if it is removed from the vehicle
even once. Replace with a new starter interlock switch when installing.
1. Remove the battery cover..
2. Disconnect the negative battery cable..
3. Disconnect the starter interlock switch connec ...
No.6 Bsm Indicator Light Flashes While Not Under Bsm Indicator Light Flashing
Conditions (No Combination Switch Operation (Turn Signal Switch)) [Blind Spot Monitoring
(Bsm)]
6
BSM indicator light flashes while not under BSM indicator light-flashing
conditions (no combination switch operation (turn signal switch)
Description
The BSM indicator light flashes despite not satisfying the BSM indicator
l ...
Non Return Valve Inspection [Skyactiv G 2.0]
WARNING:
Fuel is very flammable liquid. If fuel spills or leaks from the pressurized
fuel system, it will cause serious injury or death and facility breakage. Fuel
can also irritate skin and eyes. To prevent this, always complete the “Fuel
Line Safety Procedure”, while referring to ...