Mazda 3 manuals

Mazda 3 Service Manual: Pilot Bearing Inspection [G35 M R]

Mazda 3 Service Manual / Drivetrain / Transmission/Transaxle / Automatic / Pilot Bearing Inspection [G35 M R]

1. Perform the following procedures.

a. Remove the battery cover..

b. Disconnect the negative battery cable.

c. Remove the battery component. (ex: battery, battery tray and PCM component).

d. Remove the air cleaner component..

e. Remove the exhaust manifold insulator installation bolts and set the exhaust manifold insulator aside.

f. Remove the exhaust manifold bracket..

g. Remove the front splash shield..

h. Remove the aerodynamic under cover No.2..

i. Remove the starter..

j. Drain the transaxle oil into a suitable container..

k. Remove the manual transaxle..

2. Without removing the pilot bearing, turn the bearing while applying force in the axial direction.


Pilot Bearing Inspection [C66 M R]
1. Without removing the pilot bearing, turn the bearing while applying force in the axial direction. If there is any malfunction, replace the pilot bearing.. ...

Pilot Bearing Inspection [G66 M R]
1. Perform the following procedures. a. Remove the battery cover.. b. Disconnect the negative battery cable. c. Remove the battery component. (ex: battery, battery tray and PCM component). d. ...

Other materials:

Restraints SST [Standard Deployment Control System]
49 H066 002 Deployment tool 49 D066 002 Adapter harness 49 L066 002 Adapter harness 49 B066 004 Adapter harness 49 N088 0A0 Fuel and Therm ...

Sunroof Switch Inspection
NOTE: The sunroof switch is together with the front map light. 1. Disconnect the negative battery cable.. 2. Remove the map light from the headliner.. 3. Inspect for continuity between the sunroof switch terminals using an ohmmeter. If not as specified, replace the sun ...

Rear Combination Light Removal/Installation
4SD 1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Trunk mat. b. Trunk board. c. Trunk end trim. d. Trunk side trim. 3. Disconnect the connectors shown in the figure and remove the nuts. 4. Pull the rear combination light in the direction of the arrow ...

© 2016-2024 Copyright www.mazda3tech.com